Audio International PA-7500A Installation Manual - page 6
Audio International, Inc. PA-7500A Installation
Document # 540056A, Rev. A, 7/2000
Page 5 of 11
3.0
Installation
3.1
Prior to Installation
3.1.1 During the design and layout of the aircraft cabin, careful
consideration of the location of this module is necessary. Some of
the items to be considered include:
•
Space
•
Available power supply
•
Environmental conditions (temperature, humidity, etc.)
•
Length of cable runs
3.1.2 The PA-7500A shall be installed to conform to the standards
designated by the customer, installing agency, and existing
conditions as to the unit location and type of installation.
3.1.3 Mounting screws are required to secure the unit. Refer to
Section 6.0, Reference Drawings, for mounting hole diameters and
configuration.
3.1.4 The unit must be located as close to source equipment as possible.
Long low-level runs may introduce noise into the audio signal.
3.2
Unpacking and Inspection
Carefully open the packaging and remove the unit. Verify that all
components have been included in the package per the packing list.
Inspect the unit for damage. Retain the packing materials and packing
list.
If damage has occurred during shipping, a claim must be filed with AI
within 24 hours and a “Return Request Authorization Number” must be
obtained from AI. Refer to the front cover of this manual for address and
telephone number of Audio International. Repackage the unit in its
original packaging materials and return it to AI following instructions given
by the AI representative. If no return is necessary, retain the packing
materials for storage or reshipment if necessary.