Audio International RCP-020-x Installation Manual - page 6
AUDIO INTERNATIONAL, INC.
3/98
6
Document #540068, Rev. IR, Model No.: RCP-020-x & RCP-021-40x
AI source equipment is configured to accept digital infrared commands. Digital
codes allow the source equipment to interface with an infrared handheld remote
control (AI-RC1-17xxxx) via infrared receiver, IFR-9A. Multiple units can be
controlled independently using available programming pins. The infrared code
allows up to four (4) similar devices to be used in the same system while
maintaining independent control. To install multiple units, contact Audio
International, Inc.
2.0 Installation
2.1
Prior to Installation
The RCP is a simple AM-FM cassette tape player to use and install. The RCP is
capable of accepting infrared digital input and/or a RS-485 two-wire digital data
bus input. All audio input and output cables on the unit should be twisted
shielded pair (24 AWG minimum) unless otherwise specified. The unit must be
attached to conform to the standards designated by the customer, installing
agency, and existing conditions as to the unit location and type of installation.
The following should be carefully considered before installing:
2.1.1 Select a mounting location for the unit where 28 VDC power and audio
signal has been previously installed. Long low-level runs may introduce
noise into the audio signal. Refer to Section 5.0 Specifications and
Drawings for location of mounting points.
2.1.2 Locate the unit to allow easy audio level adjustments. Level adjustment
controls are located on the rear of the unit. These adjustment level
controls must be accessible for periodic system adjustments.
2.1.3 All headphone amplifiers and line level amplifiers should be located no
more than three feet away from source equipment.
2.1.4 Avoidinstalling the unit where it will be exposed to excessive heat,
excessive moisture, splashing liquids, dusty areas, direct sunlight, or
angled/inclined installations.
2.2
Unpacking & Inspection
2.2.1 Carefully open the packaging and remove the cassette tape player / AM-
FM Tuner. Verify that all components have been included in the package
per the packing list. Inspect the unit for damage. Retain the packing
materials and packing list. The components should arrive in good
condition.