Audio International VCP-014-01-x Installation & Operation Manual - page 9
VCP-014-0x-x Installation & Operation Manual
Document #540097, Rev. B, 09/2001
Page
8
of
21
2.0
Unpacking and Inspection
2.1 Carefully open the packaging and remove the unit. Verify that all
components have been included in the package per the packing list.
Inspect the unit for damage. Retain the packing materials and packing
list.
2.2 If damage has occurred during shipping, a claim must be filed with AI
within 24 hours and a “Return Request Authorization Number” must be
obtained from AI. Refer to the front cover of this manual for address and
telephone number of Audio International. Repackage the unit in its
original packaging materials and return it to AI following instructions given
by the AI representative. If no return is necessary, retain the packing
materials for storage or reshipment if necessary.
3.0
Cautions & Warnings
3.1 It is important to do a pin-to-pin power and ground check on all
connectors. Ensure that power and ground are applied only where
specified. Damage to the unit may result if power or ground is applied to
the wrong points.
3.2 DO NOT connect or disconnect the unit while power is applied.
3.3
DO NOT remove any factory-installed screws. Damage to the unit may
result and void any warranties.
3.4
DO NOT drop the unit or subject it to strong shock. The unit contains
glass parts that may break or crack.
3.5
DO NOT place foreign objects into openings. Contact with foreign objects
may result in dangerous voltage or electric shock.
3.6 DO
NOT place near strong magnetic fields, radiators or other heat
sources.
3.7
DO NOT use this unit other than for its intended purpose. Doing so might
lead to electric shock or injury.
3.8
DO NOT use near water, moisture, or volatile sprays. Do not use any type
of solvent when cleaning as surface damage may occur.