Audio Pole PA 4-250 User Manual - Fonctions Et Réglages
22, 23, 26, 27 - INPUT
XLR balanced inputs.
24, 25, 34, 35 - OUTPUT
Speaker outputs on screw terminals. Check the tightness of the cables before use.
28, 33, 36, 41 - Levels
Adjust the levels of the input signals.
29, 32, 37, 40 – Output selector
Position 4 Ω allows the use of standard speakers. Be careful, do not use loads less than 4 Ω at risk of
damaging the amplifier.
The 70 V or 100 V position requires speakers equipped with 70 V or 100 V line transformers and a parallel
connection.
For these two modes, the sum of the powers of the speakers must not exceed the nominal power of
the amplifier. For example, it will not be possible to use more than 25 speakers 10 W on the same channel.
The selector must be activated when the power is turned off and disconnected from the speaker outputs.
30, 38 - MONO DUAL
In the case of a Mono signal for which two amplifier channels are required, the switch must be set in MONO
mode. The signal of one of the inputs is automatically send the other, which avoids an additional wiring. For
example, for channels 1 and 2 connect the audio source to input 1, for channels 3 and 4 connect the source to
input 3. For standard use, meaning one signal per channel, turn the switch in DUAL position.
31, 39 - L/H
Switching on/off function of a band pass filter for 70 V or 100 V mode. This filter allows to eliminate any hum or
background noise and protects the speakers.
42 – AC INPUT
Power outlet. Before any connections make sure that the power cable is not damaged. The connection to the
mains supply must have an earth connection. The mains voltage supplied must conform with the electrical
characteristics of the appliance (see Chapter 5).
Fonctions et réglages
5
3
Back Panel
24
22
42
23
25
26
27
28 29
30 31
33
32
34
41
40
39
38
36
37
35