Audio Space GALAXY 34 Manual - page 4
4
OPERATING INSTRUCTIONS
(I) BEFORE UNPACKING
The carton should be placed on a flat surface with the arrows pointing upward.
(II) UNPACKING
Besides this instruction manual, you will find the following contents:
(1) one AUDIO SPACE Galaxy 34 amplifier, (2) a power supply cord, (3) handling
gloves and wiping clothe, (4) two pieces of spare fuse, (5) a remote-control unit
(batteries supplied).
To unpack:
1. remove the top covering foam pad from the carton,
2. carefully lift the amplifier out of the box by holding both sides of the amplifier
and transfer it onto a flat surface,
3. remove the plastic bag and protecting paper from the amplifier,
4. remove the vacuum tube protective cage by lifting it straight up,
5. remove all protective padding from the vacuum tubes and make sure the tubes
are seated in their sockets properly afterward,
6. remove all protective clear plastic film from the chassis and transformers,
7. replace the vacuum tube protective cage,
8. move the amplifier to where you will connect it to your audio system.
NOTE:
F
If you find any obvious damage to any of the contents, please contact your
authorized dealer immediately.
F
You may want to save the carton and packing material for future use.
F
Please check whether your line voltage is the same as that marked on this unit.
If not, please contact your authorized dealer or our company.
(III) CONNECTING
Connecting the amplifier to your audio system:
• AUDIO INPUT
With signal cables (not provided), connect your sound source(s) to the amplifier
using the suitable input terminals (CD, AUX1, AUX2) on the rear panel. Do not
mix the L and R channel signals between the amplifier and the sound sources.
DIR IN – This integrated amplifier can be used as a stereo power amplifier in
conjunction with an external pre-amplifier. Using the DIR IN terminals will
bypass the VOLUME control circuitry.
• SPEAKER OUTPUT
With speaker cables (not provided), connect the loudspeakers to the output
terminals of the amplifier that have the suitable output impedance on the rear
panel of the amplifier. Be sure to match the L and R channels of the amplifier to
the L and R loudspeakers. The 0 ohm terminals should be connected to the
negative terminal of the loudspeakers while the 4 or 8 ohm terminals should be
connected to the positive terminal of the loudspeakers.