At-lp1240-usb professional dj direct-drive turntable (usb and analog) installation and operation.
2 safety instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use the apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. ...
3 18 19 20 22 21 23 7 8 9 10 11 6 12 13 15 14 16 17 3 4 5 main features figure 1 1. Power dial controls power to the unit. 2. Dual start/stop buttons engages and disengages the motor/platter. 3. Platter speed buttons select 33 or 45 rpm platter speed. (note: 78 rpm is selected by pressing both the 3...
4 rear view diagram figure 2 24. Phono/line output rca jacks allows connection to a stereo system equipped with either a phono- or line-level input 25. Ground lug (threaded thumb screw) for connection to a pre-amp or ground lug of audio device. 26. Pre-amp selector switch allows the internal stereo ...
5 initial setup (continued) 5. While gently holding the headshell, carefully rotate the counterweight until the tone arm is horizontally balanced and hovers freely just above the platter without touching the platter surface. 6. Lock the tone arm back into the tone arm rest. 7. While holding the coun...
6 operation for best results, do not install or operate this unit near conditions of heat, moisture, dust, or heavy vibrations. (note: bright fluorescent lights may affect the visibility of the speed-indicating strobe dots. If this is a problem, simply cover the area with your hand, an album cover, ...
7 troubleshooting (continued) specifications † • when lifting or replacing the turntable cover, handle it gently. • do not touch the stylus tip with your fingers; avoid bumping the stylus on the turntable mat or a record’s edge. • clean the stylus tip frequently, following the stylus manufac- turer’...
Register your product online at www.Audio-technica.Com u.S. One-year limited end-user warranty select audio-technica brand products purchased in the u.S.A. From an authorized audio-technica (a.T.U.S.) dealer are warranted for one year from date of purchase by a.T.U.S. To be free of defects in materi...
