B-52 ACTPRO12M Instruction Manual - Actpro
THE BEAUTY OF POWER
B-52 ACTPRO Active Systems - Instruction Manual
ACTPRO
16
CONNECTIONS
Example#3
This example shows a two-channel (stereo) setup utilizing two full-range cabinets and two subwoofers. The
Full-range speakers (ACTPRO12M, ACTPRO15) are pole mounted atop the ACTPRO1S8. You may also use
a ACTPRO1515 stacked on each ACTPRO18S. Audio signals for the Left and Right channels are supplied by
themixerconsole,inthisexample,aProdigyFX.TheleftchanneloutputfromthemixerisconnectedtotheL
INPUT connector on ACTPRO18S subwoofer. The Right channel output from the mixer is connected to the L
INPUT connector on another ACTPRO18S subwoofer. The left input is used on both subwoofers.
AnXLRcableisthenconnectedfromtheLeftHPOUTPUTfromACTPRO18S,totheINPUTofthefull-range
loudspeakerontheleftside.Likewise,anotherXLRcableisconnectedfromtheLeftHPOUTPUToftheACT-
PRO18S, to the INPUT on the full-range loudspeaker on the right side.
Note: If you are using a subwoofer other than ACTPRO18S for your setup, and this subwoofer does not have
100Hz High Pass outputs but only Full Range outputs, set the 100 Hz FILTER on you ACTPRO full-range cabi-
nets to the ON position.
Note: If using connection set-up below, set the LOW-CUT switches on the Full-range speakers to the OFF
position. The signal is processed by the ACTPRO18S subwoofers.