B&B EIDM-EXTEND-2 Quick Start Manual
EIDM-EXTEND-2-3510qsg
International Headquarters: 815-433-5100
www.bb-elec.com
European Headquarters: +353 91 792444
www.bb-europe.com
1
Items Included
2
Hardware Installation
3
Front Panel & LED Chart
Quick Start Guide
EIDM-EXTEND-2
Long Range Ethernet Extender
Front Panel LEDs
Port LEDs Status Description
Steady
Green
Power on
POWER
Off
Power off
TEST Yellow
Self testing after
powered on
Steady
Green
Ethernet
connection at 100
Mbps
LAN1
LAN2
(RJ45)
100
Off
Ethernet
connection at 10
Mbps
Steady
Valid Ethernet
connection
established
Flashing
Ethernet data
activity on port
LAN1
LAN2
(RJ45)
LAN1
LAN2
Off
No valid Ethernet
connection or
activity
Steady
Green
Loop connection
established
Flashing
Green
Loop connection
in progress
Line
(RJ48)
Loop 1
Loop 2
Off
Not connected
1.
The extender is rack mountable and can be located in
environments with temperatures ranging from 0 to
50°C. Relative humidity should be between 5% and
95%, non-condensing.
2.
To mount the extender on a 19” rack, fasten the
brackets on the extender by placing the shortest sides
next to extender. Mounting the longer sides next to
extender will result in a 12” wide mount opening. You
may also choose to apply the supplied rubber feet to
the bottom of the unit and place extender on a flat
level surface.
3.
Provide AC power to unit, between 100 and 240 volts,
depending on your country’s voltage, using the
supplied power cord.
Replacement fuse: 250V, 2 Amp, 5 x 20mm.
4.
Connect the Ethernet cable to the RJ-45 port on the
back of Ethernet Extender marked LAN1. LAN2 is
available for connecting a second separate LAN over
the same G.SHDSL link.
5.
Connect a RJ-48 cable to the line port on the back of
the Ethernet Extender. The opposite end connects
with paired Ethernet Extender located elsewhere.
The cable must be terminated with an RJ-48 or RJ-45
connector and may be 1 or 2 pairs (loops). Pins 4 & 5
for loop 1 and pins 1 & 2 for loop 2. Maximum speed
is achieved using both loops. Single pair operation will
achieve the same distance but at half the speed.
o
Long Range Ethernet Extender
o
This Quick Start Guide
o
Power
Cord
o
Cat 5 Ethernet Cable
o
RS232
Cable
o
Rack Mount Brackets
o
Manual on CD
o
Rubber
Feet
The 8 LED indicators on the front of the Extender display
product status as described below.
The EIDM-EXTEND-2 provides G.SHDSL (Single-pair
High-bit-rate Digital Subscriber Line) broadband full-duplex
transmission with bandwidth aggregation up to 10.8 Mbps
over two pairs of copper line for point-to-point LAN
connectivity between two Ethernet networks. This is
enough speed to support VoIP, Web hosting, and
teleconferencing. The EIDM-EXTEND-2 conforms to the
ITU-T Rec. G.991.2, to meet G.shdsl.bis network
requirements.
Note: 8-pin RJ48 and RJ45
connectors are identical. Cable
is straight through.