B&B Electronics iMcV-LIM 10/100 Operation Manual

Summary of iMcV-LIM 10/100

  • Page 1

    Imcv-lim 10/100 operation manual ii fcc radio frequency interference statement this equipment has been tested and found to comply with the limits for a class b computing device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interfere...

  • Page 2

    Iii table of contents fcc radio frequency interference statement .................................................... Ii limited lifetime warranty .................................................................................. Ii about the imcv-lim 10/100 ............................................

  • Page 3

    2 installing an imcv-lim 10/100 the imcv modules install in b&b electronics’ snmp manageable imediachassis series or in any mediachassis. Note all modules are hot-swappable. To install an imcv modules: 1. Remove the blank bracket covering the slot where the module is to be installed by removing the ...

  • Page 4

    4 selective advertising is a mode in which the speed and duplex for the copper and the fiber are specifically advertised. This mode is available when dsw 1-4 are set to off. Troubleshooting features the imcv-lim 10/100 media converters include two advanced troubleshooting features to help locate “si...

  • Page 5

    6 led operation the imcv-lim 10/100 features several standard and diagnostic leds per port. Lnk act 100 lfd pnp (an) pwr 100 act lnk twisted pair port glows green when a twisted pair link is established. Glows yellow when data is detected on the port. Glows yellow when 100 mbps data is detected on t...

  • Page 6

    8 specifications operating temperature + 32°f to +122°f (0°c to +50°c) storage temperature -4°f to 158°f (-20°c to +70°c) humidity 5 - 95% (non-condensing) power consumption (typical) 650 ma max. @ 5 vdc for fiber optic specifications, visit the b&b electronics web site. 9 b&b electronics technical ...

  • Page 7

    10 fiber optic cleaning guidelines fiber optic transmitters and receivers are extremely susceptible to contamination by particles of dirt or dust, which can obstruct the optic path and cause performance degradation. Good system performance requires clean optics and connector ferrules. 1. Use fiber p...

  • Page 8

    12 certifications ce: the products described herein comply with the council directive on electromagnetic compatibility (2004/108/ec). For further details, contact b&b electronics. European directive 2002/96/ec (weee) requires that any equipment that bears this symbol on product or packaging must not...