B+B SmartWorx ABDN-ER-DP551 Quick Start Manual
1-888-948-2248 | Europe: +353 91 792444
advantech-bb.com
707 Dayton Road | PO Box 1040 | Ottawa, IL 61350
Phone: 815-433-5100 | Fax: 815-433-5109
www.advantech-bb.com | E-mail: support@advantech-bb.com
Fast and easy on the web:
www.advantech-bb.com
QUICK START
GUIDE
LED
COLOR
AIRBORNE DEVICE STATE
POWER
Off
Adapter is not powered.
Red
Adapter failed Power On Self Test (“POST”).
Amber
Adapter passed POST but is not configured for wireless network
communication.
Green
Adapter passed POST and is configured for wireless communication.
LINK
Off
Adapter is not powered.
Red / Off
(Periodic Blinking) Adapter is searching for a valid network (Access
Point) that matches device’s configuration.
Green
Adapter has successfully associated with an Access Point.
COMM
Off
If Power LED is also Off, then Adapter is not powered.
If Power LED is On, then either:
• A physical connection detected on Serial/Ethernet cable.
• No TCP session from wireless interface has been established.
Red
No physical Ethernet connection has been detected.
Red / Off
(Blinking – OFF/Red) A physical Ethernet connection has been
detected and there is traffic across the interface. No TCP connection
to the adapter has been established on the wireless interface.
Document Number: 710-11219-00_R0_ABDN-ER-DP551x_1117qsg
More AirborneM2M Products
Embedded Dual-band M2M
Access Point Module
# APMN-Q551
Before you begin, be
sure you have the following:
ABDN-ER-DP551 &
ABDN-ER-DP551U
Wireless Ethernet Adapter
+ ABDN-ER-DP551 or ABDN-ER-DP551U
+ (ABDN-ER-DP551) 5 VDC power supply,
with 2.1 mm barrel jack
OR
(ABDN-ER-DP551U) Dual (Y) USB power cable,
with 2.1 mm barrel jack
+ 50 Ohm, omni-directional antenna
+ CD with Airborne Management Center Software
If your device is connected and configured correctly, you
will see the following LED Status:
POWER: Green
LINK:
Green
COMM: Red / Flashing Red
(Continued)
Check Your Setup
7
802.11 Wireless Bridge,
Router & Serial Server
# ABDN-ER-IN5010
Troubleshooting
8