B+B SmartWorx EIS2-EXTEND-A Quick Start Manual - page 2
Product Overview
Set the DIP Switches
Connect the EXTENDERS
LEDS for LAN Port
LEDS for VDSL2 Port
1
2
5
3
Select the DIP Swtich settings based on the VDSL2
Profile for the Master and Remote EIS2-EXTEND-A
devices.
Ethernet Port (RJ-45): Use a straight through or
cross-over cable. CAT 5 or higher
VDSL2 Port (RJ-11): Use a CAT 3 cable
4
STEP 1
:
Set the EIS2-EXTEND-A to CO
mode or CPE mode from the DIP
switch at the front panel. For Point to
Point applications, one unit must be
Master (CO mode) and the other one
is Slave (CPE mode).
STEP 2
:
Connect the EIS2-EXTEND-A (CPE)
with a regular Cat. 5 cable to the
LAN port from a PC or another
device on LAN.
STEP 3
:
Power on EIS2-EXTEND-A (CPE) by
connecting the power adapter.
STEP 4
:
Connect the CPE and CO via a
regular Cat. 5 cable or a
telephone wire from each VDSL2
port.
STEP 5
:
Connect the EIS2-EXTEND-A (CO)
with a regular Cat. 5 cable to the
LAN port and then connect the other
end of the RJ45 cable to the service
equipment.
STEP 6
:
Power on EIS2-EXTEND-A (CO) by
connecting the power adapter and
then observe the status of VDSL2
link LED.
Installation Steps