B+B SmartWorx UR5i v2 Start Manual - page 5
Start Guide
2. SIM Card
The SIM card reader, for 3 V and 1.8 V SIM cards, is located on the front panel of the
router. Full version of the router contains two readers. If you intend to use this device to com-
municate over a cellular network, please place an activated data-provisioned SIM card with an
unblocked PIN into the SIM card reader. Insert your SIM card into the SIM1 or SIM2 holder
and push it to the reader (see Figure below).
Before handling of the SIM card disconnect the router from power supply!
3. Power
The router requires an external DC power supply. The DC voltage required is between
+10 to +30 V DC. The router has built-in protection against reverse polarity without signaling.
Connect the power supply cable to the PWR connector on the front panel of the router (see
Figure below) and tighten locking screws.
QSG-0001-EN, June 1, 2017
4
Released in the Czech Republic