Before operating this tool, all operators should study this manual to understand and follow the safety warnings and instructions. Keep these instructions with the tool for future reference. If you have any questions, contact your representative or distributor. Us7116 lmauto upholstery stapled operat...
-2- index safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3, 4 air supply: fittings, hoses, filters, air consumption, regulators, operation pressure, setting correct pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . 5...
-3- safety instructions eye protection which conforms to ansi specifications and provides protection against flying particles both from the front and side should always be worn by the operator and others in the work area when connecting to air supply, loading, operating or servicing this tool. Eye p...
-4- air supply and connection do not use oxygen, combustible gases, or bottled gases as a power source for this tool as tool may explode, possibly causing injury or death. Do not use supply sources which can potentially exceed 200 p.S.I.G. As tool may burst, possibly causing injury. The connector on...
-5- air supply and connections do not use oxygen, combustible gases, or bottled gases as a power source for this tool as tool may explode, possibly causing injury. Keep the tool pointed away from yourself and others when connecting air source. Fittings: install a male plug on the tool which is free ...
-6- driving power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . 58 in.Lbs fastener type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 gaug...
-7- loading to prevent accidental injuries: • never place a hand or any other part of the body in nail discharge area of tool while the air supply is connected. • never point the tool at anyone else. • never engage in horseplay. • never pull the trigger unless nose is directed at the work. • always ...
Tool operation eye protection which conforms to ansi specifications and provides protection against flying particles both from the front and side should always be worn by the operator and others in the work area when connecting to air supply, loading, operating or servicing this tool. Eye protection...
-9- in addition to the other warnings contained in this manual observe the following for safe operation • use the b&c eagle pneumatic tool only for the purpose for which it was designed. • never use this tool in a manner that could cause a fastener to be directed toward the user or others in the wor...
Maintaining the pneumatic tool when working on air tools, note the warnings in this manual and use extra care evaluating problem tools. Caution: pusher spring (constant force spring). Caution must be used when working with the spring assembly. The spring is wrapped around, but not attached to, a rol...
-11- trouble shooting problem cause correction frame/nose leaks air loose nose screws . . . . . . . . . . . . . . . .Tighten and recheck o-ring or gasket is cut or cracked . . .Replace o-ring or gasket bumper cracked/worn . . . . . . . . . . . . .Replace bumper frame/cap leaks air damaged gasket or ...
