B&D Controll-A-Door R Instruction Manual - Section 4 - How to Operate
SECTION 4 - HOW TO OPERATE
For maximum efficiency of your opener, your garage door must be in good operating condition. An annual service of
the door by an authorised dealer is recommended. (Refer to Warranty conditions in Section 8).
Activate the opener only when the door is in full view, free of obstructions and with
the opener properly adjusted. No one should enter or leave the garage while the door
is in motion. Do not allow children to play near the door.
This opener is a mains voltage plug-in domestic appliance and there are
no user serviceable parts inside this opener
4.1 Remote Control Transmitter
•
To operate the garage door opener, press the programmed button of the remote control transmitter until your
door begins to move (usually 2 seconds). For an entry keypad, enter the coded pin number (or name), press and
hold the enter button for 2 seconds until the door starts to move.
•
Make sure you can see the door when you use the remote control
transmitter.
•
If you are in a vehicle you should aim the remote control transmitter
through your windscreen. If your remote control transmitter has a visor
clip, it should be secured to the visor so that when the remote control
transmitter is operated it is transmitting through the vehicle windscreen.
•
Check that the door is fully closed before you drive away.
•
If you press the remote control transmitter whilst the door is moving:
i.
Downwards – the door will stop and then reverse to the open position.
ii. Upwards – the door will stop, with the next press of the remote control transmitter the door will move
downwards.
Note: Once the door is moving, the operating distance of the remote control transmitter is significantly
less than when the door is stationary.
The remote control transmitter may also be programmed to operate the following features (see the section on
Programming Optional Remote Control Transmitter Features):
•
to turn the courtesy light on and off without operating the door,
•
to activate the Auxilliary Output, and/or
•
to put the garage door opener into “Vacation Mode” where it will not respond to any remote control transmitters.
Additional remote control transmitters may be purchased at any time.
©Copyright 2003
17
Part No 059778