1. DL manuals
  2. B&D
  3. Garage Door Opener
  4. Easylifter
  5. Installation Instructions Manual

B&D Easylifter Installation Instructions Manual

Other manuals for Easylifter: Instructions Manual
Manual is about: ROLLING GARAGE DOOR OPENER

Summary of Easylifter

  • Page 1

    Rolling garage door opener owners copy warning: it is vital for the safety of persons to follow all instructions. Failure to comply with the installation instructions and the safety warnings may result in serious personal injury and/or property and remote control opener damage. Please save these ins...

  • Page 3

    Important safety instructions b&d doors & openers pty ltd (b&d) to the extent that such may be lawfully excluded hereby expressly disclaims all conditions or warranties, statutory or otherwise which may be implied by laws as conditions or warranties of purchase of a b&d rolling garage door opener. B...

  • Page 4: Features

    4 features your easylifter auomatic rolling garage door opener has many features which you will appreciate. The components and materials used in this automatic opener are of the latest technology and highest quality. Listed below are some of the many features. Operation to open or close the door sim...

  • Page 5

    5 operating controls 1. Light code button (white) is used for storing or erasing the transmitter button (code) you wish to use to turn the opener’s courtesy light on and off. 2. Door code button (blue) is used for storing or erasing the transmitter button (code) you wish to use to command the door t...

  • Page 6

    Operating controls 6 1) light code button (white) 2) door code button (blue) 3) close drive button (red) 4) close limit led (red) 5) auto close button (white) 6) reset button 7) o/s/c button (yellow) 8) close limit adjust screw (red) 9) open limit adjust screw (green) 10) open limit cam (green) 11) ...

  • Page 7: Package Contents

    Package contents 7 item quantity easylifter drive unit 1 hand held transmitter 1 alkaline battery a23 12v 1 weight bars (not included in some models) 2 screw m5x40mm (not included in some models) 4 hex nut m5 (not included in some models) 4 spring washer i.D 5 (not included in some models) 4 screw #...

  • Page 8: Before Installation

    Before installation 8 important safety instructions for installation warning: incorrect installation can lead to severe injury. Follow all installation instructions. Side room requirements fig. 1 shows the minimum side room that is required. The distance between the edge of the door curtain and the ...

  • Page 9

    Mounting the opener 9 fig. 11 fig. 12 check if “u” bolt is tight remove “u” bolt remove bracket rope support prop tighten “u” bolt refit wall bracket untie rope remove prop tighten locking bolts 4. Fixing drive unit to the door the easylifter drive assembly can be fixed to the rolling garage door in...

  • Page 10

    Setting limits 10 5. Fixing of door curtain to drum wheel the door curtain has to be secured to the drum wheel with suitable fasteners. 1. With the door in the fully closed position, mark the curtain (fig. 13) on both ends of the door. 2. Open door slightly to have access to the marked positions. Se...

  • Page 11

    Setting limits 11 note: if the door has not reached the desired limit position by more then 30mm, then it is recommended that the green limits cam be adjusted again before the green fine adjustment screw is adjusted. Close limit adjustment press in and hold the red close button . (fig. 16). The door...

  • Page 12

    Setting limits 12 open limit adjustment press and hold the green open button (fig. 18). The door should start opening. Release the open button when the door reaches the desired open limit stop position. If the green led (fig. 18) is illuminated and the desired limit stop position has been reached th...

  • Page 13

    Setting safety obstruction force 13 7. Setting open and close safety obstruction force the safety obstruction force is calculated automatically and set in memory on the easylifter. This applies to both the open force and close force. Warning: when step 7.1 is initiated the garage door will do a full...

  • Page 14: Coding Transmitters

    Coding transmitters 14 8. Storing transmitter codes make sure to connect the battery to the transmitters. The memory in the openers receiver can store up to remote control transmitters buttons. 8.1 storing transmitter code fig. 22 press and hold door code button press the button for two seconds 1. P...

  • Page 15

    Coding transmitters 15 11. Setting the transmitter to operate the courtesy light 12. Adjusting courtesy light time the preset courtesy light time on the door opener is 3 minutes. This time can be changed as below. 1. Press and hold the auto close time and force margin set buttons together (fig. 26) ...

  • Page 16: Pe Beam and Auto Close

    Pe beam and auto close 16 14. Fitting the safety photo electric beam sensor (optional) locate the photo electric beam (p.E.) normally closed contact type in a strategic location within doorway. We recommend 150mm above the floor level and as close as possible to the door opening, inside the garage. ...

  • Page 17: Technical Specifications

    Parameters & specifications 17 door opener state open led green close led red door status led yellow beeper open on close on opening flashing closing flashing door travel stopped flashing flashing door obstructed when opening flashing door obstructed when closing flashing beeps while door is moving ...

  • Page 18

    Trouble shooting 18 *please note: some areas may be prone to excessive radio interference brought on by devices such as cordless telephones, wireless stereo headphones and baby monitors. It is possible that these devices could cause a degree of interference such as to greatly reduce the range of the...

  • Page 19: Spare Parts List

    Spare parts list 19.

  • Page 21

    ©copyright 2006 b&d doors p/n: 05xxx - 20 - 1. Definitions ‘b&d’ means (a) in australia - b&d doors of 17 oasis court, clontarf, queensland, 4019, a division of b&d australia pty ltd (abn 25 010 473 971), or (b) in new zealand - b&d doors nz ltd of 70 allens road east tamaki auckland, which is a sub...

  • Page 22

    ©copyright 2006 b&d doors p/n: 05xxx - 21 - 9. Subject to paragraph 12 hereof; (i) the obligations of b&d under this warranty are limited to those contained herein and such warranties are expressly in lieu of all other warranties, express or implied, including any implied warranty of merchantability...

  • Page 24

    Qld office: 17 oasis court, clontarf 4019. Ph: (07) 3883 0200 nsw office: 34-36 marigold st, revesby 2212. Ph: (02) 9722 5555 vic/tas office: 147-153 canterbury road, kilsyth 3137. Ph: (03) 9237 7766 sa office: 23 frederick road, royal park 5014. Ph: (08) 8440 4747 wa office: 96 mulgul drive, malaga...