1. DL manuals
  2. B&D
  3. Garage Door Opener
  4. Econolift ML500
  5. Installation Instructions Manual

B&D Econolift ML500 Installation Instructions Manual

Summary of Econolift ML500

  • Page 1

    Owners copy installation instructions warning it is vital for the safety of persons to follow all instructions. Failure to comply with the installation instructions and the safety warnings may result in serious personal injury and/or property and remote control opener damage. Please save these instr...

  • Page 2

    Start by reading these important safety rules warning: if your garage has no service entrance door, a combo access device must be installed. This accessory allows manual operation of the garage door from outside in case of power failure. Keep garage door balanced. Sticking or binding doors must be r...

  • Page 3

    C co om mp plle ette ed d iin ns stta alllla attiio on n as you proceed with the assembly, installation and adjustment procedures in this manual, you may find it helpful to refer back to this illustration of a completed installation. 4 (1) cable pulley bracket (2) trolley (3) chain/cable assembly (4...

  • Page 4

    Installation section wear protective goggles when working overhead to protect your eyes from injury. Disengage all existing garage door locks to avoid damage to garage door. To avoid serious personal injury from entanglement, remove all ropes connected to garage door before installing opener. It is ...

  • Page 5

    B 5 4 4 a 1 3 4 2 3 2 4 4 1 2 connect door arm to trolley a. Preferred installation: disconnect trolley by pulling on the red handle and slide towards door. With door closed connect straight door arm (5) to trolley (4) with bolt (3), secure with nut (1). Connect curved door arm (2) to door bracket w...

  • Page 6

    Program remotes activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Your garage door opener receiver and remote control transmitter are set to a matching code. If you purchase additional remote co...

  • Page 7

    Operation of your opener your opener can be activated by any of the following devices: • the remote control transmitter. Hold the push button down until the door starts to move. • the outside keylock or keyless entry system (if you have installed either of these accessories). Opening the door manual...

  • Page 8

    Distributor in obtaining access where the product is not readily accessible - you will need to pay for those additional expenses. 5 what voids the warranty - subject to clause 6, this warranty does not extend to, and b&d will be relieved of, all obligations, responsibilities and liabilities in the e...