B&D tri-tran 062269 Installation Instructions
PN 72964 TRI-TRAN™ Wireless Keypad Installation Instructions. Revision 1.02 A
TRI-TRAN™ WIRELESS KEYPAD
INSTALLATION INSTRUCTIONS
PART NO 062269
Tri-Tran™ Wireless Digital Keypad is designed for use with automatic
garage door and gate openers. The Tri-Tran™ format provides
unparalleled security with more than 99 million different codes. To
operate, the user enters their unique pin code on the Wireless Keypad (4
to 8 digits long) followed by the hash (#) key. The user then presses one
of the eight available channels.
Familiarise yourself with the following instructions prior to commencing
set up. Store this information including your new pin code in a safe place
for future reference.
Initial Set Up
The Wireless Keypad is supplied with a factory preset code (1111) which
must be changed to a new pin code before the Wireless Keypad will
operate. The pin code can be any 4-8 digits number except 1111.
Storing your pin code
Note: There is a timeout of approximately 5 seconds after the last button
is pressed.
Enter 1111 followed by the hash (#) key.
Press and hold the hash (#) key again. The keypad will beep for
approximately 5 seconds. Once the beeping stops, release the hash
(#) key. Enter the new pin code followed by the hash (#) key. Re-
enter the new pin code followed by the hash (#) key to confi rm. A
short string of beeps will be produced to confi rm the acceptance of
the new pin code.
Test operation using the new code. Enter the new code followed
by the hash (#) key. Press and hold any button from 1-8 and you
should hear a continuous string of beeps.
NOTE: If you lose or forget a code, you will need to return the Wireless
Keypad to B&D Doors for reprogramming. A charge will apply for this
service.
Coding The Wireless
Keypad Into The Opener
Press the CODE SET button and release. The CODE SET LED will
illuminate to indicate that the opener is in Code Learn mode. If a
valid code is not stored within 15 seconds, the opener will exit Code
Learn
(Fig. 02).
Enter your pin code on the Wireless Keypad followed by the hash
(#) key. Then press one of the eight (channel) buttons you wish to
use to operate the door or gate etc. The CODE SET LED will fl ash.
Pause for a second and press the same button again on the Wireless
Keypad. The CODE SET LED will illuminate for one second then go
out.
Test the operation of the Wireless Keypad by entering your pin code
followed by the hash (#) key and the stored channel button (1-8).
The door should start to move.
Coding The Wireless Keypad Into The Tri-Tran™ receiver
Press and hold SW1/SW2 on the Tri-Tran™ receiver board
(Fig.
03).
Enter your pin code on the Wireless Keypad followed by the hash
(#) key. Then press one of the eight (channel) buttons you wish to
use to operate the door or gate etc.
Pause for a second and press the same button again on the Wireless
Keypad.
Release the SW button. The Wireless Keypad code should now be
stored into the receiver’s memory.
Test the operation of the Wireless Keypad by entering your pin code
followed by the hash (#) key and the stored channel button (1-8).
a.
b.
c.
a.
b.
c.
d.
a.
b.
c.
d.
e.
Star(*) key
Hash(#) key
Fig.01
Fig.02
SW1
JP1
LED
JP2
SW2
Fig.03