Rs-90 rc-93 rp-100 installation and operating instr uction manual for systems, filters & service t: 952.884.8417 e: info@bdavidwater.Com w: bdavidwater.Com b.David company world health through water purification systems 9333 nanotechnology under counter water purification system hel neu st 57 rev: 1...
S p e c i f i c at i o n s : pressure range: 2.1-8.62 bar (20-115 psi) temperature range: 4.4-38.8°c (40-102°f) service flow rate @60 psi (4.1 bar): 2.3 lpm at 4.1 bar 0.6 gpm rated service life: 3,785 l (1000 gallons) dimensions: 394 mm x 133 mm x 356 mm (15.5 in. X 5.25 in. X 14 in.) weight (fille...
Pa r t s i n c l u d e d : • filter system with filter cartridges • installation hardware (mounting screws, saddle valve, fittings) • 6.35 mm (1/4-inch) tubing • lead-free faucet tools and materials required: • safety glasses • hand or electric drill (cordless recommended) • file • phillips head scr...
1. Installing the saddle valve (diagram 1) use of a hand drill is recommended. To protect yourself from serious injury or fatal shock when using an electric drill, be sure the drill and the out- let it is plugged into are properly grounded. When using a drill, follow the manufacturer’s guidelines an...
Do not attempt to drill through an all- porcelain sink. If you have an all-porcelain sink, mount the faucet in pre-drilled sprayer hole or drill through countertop next to sink. When drilling through a countertop make sure the area below the drilled area is free of wiring and piping. Make certain th...
5. Connecting the faucet (diagram 5) caution: do not over-tighten compression nut. Use caution not to bend or crimp tubes when securing. (a) locate compression nuts in installation kit and fau- cet package. (b) attach compression nuts to faucet stem and effec- tive life indicator (eli) and hand tigh...
8. Connecting the saddle valve (diagram 8) (a) locate compression nut in installation kit pack- age and attach to inlet fitting. Tighten the nut hand tight and then loosen one full turn. (b) repeat steps 6b and 6c. 9. Connecting inlet line to system (diagram 9) (a) locate compression nut in installa...
Note: initially, filtered water may appear cloudy. If you set a glass of water on a level surface, you should be able to watch the cloudiness disappear from the bottom of the glass upwards. This harm- less cloudiness results from the release of trapped air within the cartridge and will disappear wit...
Troubleshooting: • leaks between cap and bottom of filter housing: turn off water supply and turn on drinking water faucet to release pressure in system. Remove bot- tom of housing. Clean o-ring and o-ring groove (located directly beneath threads of housing). Lu- bricate o-ring with silicone grease ...
M a i n t e n a n c e hel neu st 57 date activity/service performed installation date b.David company world health through water purification systems tel: (952) 884-8417 email: info@bdavidwater.Com visit our website: www.Bdavidwater.Com.
