B&K AV6125 Owner's Manual

Manual is about: B & K Six Channel Amplifier OWNER'S MANUAL

Summary of AV6125

  • Page 1

    Av6125 six channel amplifier owner’s manual b&k components, ltd. 13002 rev 0004.

  • Page 2

    13002 rev 0004 b&k components, ltd 2100 old union road buffalo, new york 14227.

  • Page 3: Table of Contents

    Page 1 13002 rev 0004 table of contents safety precautions page 2 purpose and function page 3 design and construction page 3 features page 3 rear panel view page 4 rear panel description page 4 - 6 level controls page 5 inputs page 5 - 6 outputs page 6 control muting page 8 - 9 system installation p...

  • Page 4: Safety Precautions

    Page 2 13002 rev 0004 safety precautions please read before installing warning: to prevent fire or shock hazard, do not expose this unit to rain or moisture. The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user of the presence of uninsulated “dangerous vo...

  • Page 5

    Page 3 13002 rev 0004 the av6125's purpose and function the av6125 is a compact, very efficient, six channel power amplifier. It is designed to be used in all types of audio or audio/video systems. Design and construction the av6125 utilizes high quality electronic circuitry to achieve an environmen...

  • Page 6

    Page 4 13002 rev 0004 rear panel view 1. Ac fuse holder 4. Amplifier control muting input/output 2. Ac input receptacle 5. Level controls 3. Speaker outputs 6. Inputs rear panel description 1. Ac fuse holder - holds the ac line fuse. This fuse is an 12 amp / 250 volt slow blow fuse. Replace with sam...

  • Page 7

    Page 5 13002 rev 0004 )ljxuh% 5. Level controls - for adjusting the input level of each channel into the amplifier. There are five level controls on the back of the amplifier. One level control for each channel. Explained further below. 6. Inputs - for connecting signal patch cables (interconnects) ...

  • Page 8

    Page 6 13002 rev 0004 here is a typical preamplifier to amplifier setup: outputs five way binding posts are provided. One pair for each channel. They are designed to accept a banana-type plug or spade lug connector (shown below) and are color coded for easy identification. The red (+) post should al...

  • Page 9

    Page 7 13002 rev 0004 system installation there will most likely be a number of cables involved in the installation of your home entertainment system. Pre-planning is essential in order to maximize system efficiency. We recommend the following as a means of helping you reach that goal: make a diagra...

  • Page 10

    Page 8 13002 rev 0004 connect the audio cables from your preamplifier’s output to the corresponding input connector on the amplifier. Connect the wires from your speakers to the appropriate outputs on the amplifier. It is absolutely essential that you observe correct polarity in these connections. E...

  • Page 11

    Page 9 13002 rev 0004 if a source other than a b&k series preamplifier is used to control multiple amplifiers, only the control output voltage from the source is critical. It must be within the range, as indicated on the rear panel, 5-24 volts dc is required. The amplifier will provide each successi...

  • Page 12: ** Note

    Page 10 13002 rev 0004 troubleshooting problem possible cause possible solution no sound (‘on’ led not illuminated) 1. Power cord not plugged in. 2. Power off at ac source. 3. Ac power inlet fuse blown or faulty. 4. Control switch in the wrong position. 1. Reconnect power cord. 2. Check ac switch or...

  • Page 13: Av6125 Specifications

    Page 11 13002 rev 0004 av6125 specifications power rating: 8 ohms 125 watts @ 1 khz 4 ohms 185 watts @ 1 khz frequency response 5 hz - 45 khz input sensitivity 1.0 volts thd (s+n) 0.09 % @ 1 khz input impedance 33.2 k ohms damping factor 150 current (peak to peak) 30 amps slew rate 14 v / ) sec dyna...

  • Page 14: Limited Warranty

    Page 12 13002 rev 0004 limited warranty b&k components ltd., referred to herein as b&k, warrants your b&k equipment against all defects in material and workmanship for a period of five years from the date of purchase. This warranty applies only to the original purchaser and only to equipment in norm...

  • Page 15

    13002 rev 0004 b&k components, ltd 2100 old union road buffalo, new york 14227.

  • Page 16

    13002 rev 0004.