B-K Medical Type 8661 User Manual - page 7

 3

8661 • Starting Scanning

Connecting the Transducer

The transducer is connected to the scanner using the array Transducer Socket on the scan-

ner. To connect, the transducer plug’s locking lever should first be in a horizontal position. 

Align the plug to the scanner socket and insert securely. Turn the locking lever clockwise to 

lock in place.

When connected the transducer complies with Type B requirements of EN60601-1 (IEC 

60601-1).

Changing Frequency

The Multi-Frequency Imaging (MFI) facility enables you to select the scanning frequency. 

See the applicable scanner user guide for instructions. The selected frequency is displayed 

at the top of the screen.

Using a Transducer Cover

The transducer should be enclosed in a transducer cover or a standard condom. See the 

Product Data sheet for a list of available transducer covers.

Apply gel to the tip of the transducer. This improves the screen images by preventing image 

artifacts caused by air bubbles.

Pull the transducer cover over the transducer.

Gel also creates a good acoustic contact between the skin and the transducer; therefore, 

apply a small amount to the outside of the cover prior to scanning. Re-apply the gel fre-

quently to ensure good screen images.

Using the Transducer Control Button

The transducer has a control button that you can press to Start or Stop scanning (freeze 

frame). Press the button for more than one second to make a copy of the image.

Each time the button is pressed, a “beep” is emitted.

Changing Orientation

To change the orientation of the image on the monitor, refer to the applicable scanner user 

guide for instructions.

WARNING

Keep all plugs and sockets absolutely dry at all times.

WARNING

Because of reports of severe allergic reactions to medical devices containing latex (natural 

rubber), FDA is advising health-care professionals to identify their latex-sensitive patients 

and be prepared to treat allergic reactions promptly.

WARNING

Use only water-soluble agents or gels. Petroleum or mineral oil-based materials may harm 

the cover material.