B.M.C. M2 Quick Start Manual - page 4
POWER
INPUT
1
4
7
0
df
mute
2
5
8
ovs
3
6
9
+10
ups
+
-
+
-
check
prog
disp
rep.
clear
mute
RC-1
DAC
CD
IN
AMP
VOL
IN
VOL
4
13
Front Panel Functions
Remote Control
POWER
Turn to switch the unit ON and OFF
DIGM Display
Shows the selected DIGM Gain (00-66)
DIGM mode is only possible with an optical DIGM signal from a B.M.C.
Audio unit with DIGM Gain Control, such as the DAC1.
Attention: When this display goes out, the M2 is in Power Amplifier Mode
and gain is set to maximum, that means DIGM 66!
Maximum gain is intended for classical Pre-Amplifier / Power-Amplifier
use.
Never use the M2 in Power Amplifier Mode with a fixed level output
source!
POWER Meter
Shows actual power in WATT (at 4 Ohm)
Level indicator in dB, reference level 0 dB equals 1 W
INPUT Indicator
Shows the selected INPUT
Attention: The XLR-CI can only be selected, if an active optical DIGM
signal is present!
INPUT Selector
Turn for changing INPUT.
Attention: The XLR-CI can only be selected, if an active optical DIGM
signal is present!
The M2 does not come with a remote control
and it does not have a remote control
receiver. MUTE and VOLUME can be
controlled via an external B.M.C. Audio
DIGM control unit, such as the DAC1, if an
optical fiber connection between the two is
established.
NOT FOR M2!
When using the shown remote control RC-1
and trying to change VOLUME or MUTE,
please apply the DAC section, not the AMP
section.
Pointing the remote control RC1 at the M2
does not work, so please point at the DAC1
(or some other B.M.C. Audio unit intended
for controlling DIGM).
VOLUME Up
VOLUME Down
MUTE
Mutes the signal. (Displayed on the DAC1)
Unmute by pressing MUTE again. Changing
the volume will not unmute the signal, that
can only be done by pressing MUTE again!