B&Q 5397007212969 Assembly manual - page 4
of
4
CSS1108 09/09
Notes:
Lay plinth panel in front of cabinet legs. Position plinth clip plate opposite front
cabinet legs. Secure with 2 x screws .
Slide into . Stand plinth up.
C
u
V
T
u
u
To fit plinths
7
All legs are pre-set at 150mm height.
Rotate to adjust up and down, to level the unit.
Drill a 5mm hole through both side panels.
Join together using joining bolts .
To Fit to wall, drill 3mm pilot hole into side panel of cabinet.
Fix 2 x bracket using 2 x screws
Levelling, Joining & Fitting to Wall
A
C
d
Wall Fitting not supplied Use appropriate fittings to secure cabinet
to wall (depending on wall type).
6