B.Well WN-117 Instruction Manual - Important:
Instructions for use
WN-117
En
7
6. Attach one end of air tube to the base of the nebulizer
7. Attach the other end of air tube to the tube connector
located on the front of the compressor.
8. Attach mouthpiece or mask per your choice to the top
section of nebulizer.
9. Plug the power cord into an appropriate electrical
outlet. Make sure at this stage, the power switch is at
“OFF” status.
10. Press the power switch to “ON” status to begin your
prescribed treatment.
Important:
The compressor motor has a thermal protector, which will shut off the unit before the
unit is overheated. When the thermal protector shuts the unit off , please:
a. Switch off the unit.
b. Unplug the unit from the electrical outlet.
c. Wait 30 minutes for the motor to cool down before another treatment. Make sure
the air openings are not obstructed.
11. When treatment is fi nished, shut off the unit and unplug it from the electrical outlet.
6. CLEANING
It is recommended that the nebulizer and the mask (or any other patient accessory inter-
face that is used) be thoroughly cleaned with hot water after each use and cleaned with a
mild detergent after the last treatment of the day. If your physician or respiratory therapist
specifi es a diff erent cleaning procedure, follow their instructions.
Caution: Before cleaning, make sure the power cord is disconnected from the main
outlet and the unit.
Rinsing Technique (after each treatment)
1. Make sure the power switch has been turned to “off ” position and the unit has been
disconnected from the power source.
2. Disconnect the air tube from the base of the Nebulizer.