B2 Audio zero.7 Owner's Manual - page 5
5
CAUTION
Panel layout
Installation of the amplifier shall be done in the following steps:
1. Ensure the ground is appropriate, then connected it to the amplifier. 2. Connect the +12V wire, keep in mind this
wire has to be fused at the battery as well. 3. Connect the switched remote. 4. Reattach negative wire (ground) to
the battery. 5. Operation over 16 V will cause the amplifier to go into protect & can void the warranty!
+ 12V (POWER CONNECTION)
REM (REMOTE)
Connects to the positive terminal of the battery (+12V).
Connect to switched +12V from the headunit.
For specified performance 0 GA cable is required.
Fuses shall be placed within 20 cm / 8” of the battery.
Remember to fuse at the amplifiers end as well.
Keep the + 12V cables of equal length.
GND (GROUND CONNECTION)
For connection to the chassis’ ground.
Keep as short as possible (< 50 cm / 20”).
Use minimum 0 GA cable for specified performance.
Ensure that all GND cables are of equal length and
mounted at the same connection / shares a common ground.
Zero.7