Baalbaki ESB-SUPER Instruction Manual - page 5
04
Check if the Juice Extractor is firm in its position. Before using it, wash all food-
contacting parts with neutral soap and water.
3. Operation
3.1 Starting
IMPORTANT
Always wait until the motor complete stop before changing the crown.
Make sure the Crown is properly fitted.
To start the operation, turn on the ON/OFF Switch Nº09 (Pic-1), located on the Base
Nº 08 (Pic-01).
3.2 Feeding Procedures
Juice Extractors work with high speed. First, cut the oranges or the lemons in two
halves.
Turn the machine on, hold half of the fruit and press it down firmly against the crown
Nº05 or Nº06 (Pic-01) and the juice will run into the cup Nº04 (Pic-1) going first through the
Sieve Nº03 (Pic-01).
3.3 Cleaning
IMPORTANT
Never clean the machine when it is connected to a power point, always unplug the
machine before cleaning. Before taking out the crown, be sure the motor has come
to a complete stop.
All removable parts must be removed and washed.
Follow the below instructions for washing removable parts:
3.3.1 Turn off the machine and unplug it.
3.3.2 Remove the Lid Nº01 (Pic-01), the Crown Nº 05 or N° 06 (Pic-01) and then
the Juice Chamber Nº 02 (Pic-01)
3.3.3 Wash all removable parts with running water and neutral soap and dry
them.
3.3.4 To reinstall them, follow the above order inversely.
07
4.2 SAFETY PROCEDURES AND NOTES BEFORE SWITCHING ON
IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.
Be sure to be familiar with the instructions and that you have well understood all
information contained in this manual. If you have any question contact your
supervisor or your nearest Dealer.
4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insulation could
cause electrical shocks as well as electrical leak. Before use, check conditions of all
wires and cables.
4.2.2 Advices
Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood.
Every function and operational procedure have to be very clear to the operator.
Contact your nearest Dealer for further questions.
Any manual command (switch, button or lever) shall be given only after being
sure it is the correct one.
4.2.3 Precautions
The electric cable has to be compatible with the power required by the machine.
Cables touching the floor or close to the machine need to be protected against short
circuits.
4.3 Routine Inspection
4.3.1 Advice
When checking the tension of the belts or chains, DO NOT introduce your fingers
between the belts and the pulleys and nor between the chain and the gear.
4.3.2 Precautions
Check if motors and sliding or turning parts of the machine produce abnormal
noises.
Check the tension of the belts and chains and replace the set when belt or chain
show signs of being worn out.
When checking tensions of belts or chain DO NOT introduce your fingers
between belts and pulleys, nor between the chains and gears.
Check protections and safety devices to make sure they are working properly.