Baby Einstein 30877 Instruction Sheet - Operating Instructions
– 3 –
Operating Instructions
Introduction
The baby einstein™ button and the caterpillar character’s
five color lenses are on the front of the music mirror unit.
The Power/Mode Switch on the back of the music mirror
unit allows you to set the operating mode.
Slide the Power/Mode Switch on the back of the music
mirror unit to the Play Mode position for normal use of the
move & go music mirror. The music mirror unit must be in
Play Mode in order to respond to the RF remote control.
NOTE: If the RF remote control is not available or it has
low batteries, use the baby einstein™ button instead. See
“Front Panel Control” on page 3.
Power ON/OFF
Power ON – Press the baby einstein™
button on the front of the music mirror unit
to power ON the unit. A short musical
fanfare announces that the unit is ready to
accept control input from either the RF
remote control or the front panel button.
Power OFF – The music mirror unit prepares for auto-
shutoff 30 minutes after the last melody or learning program
has completed. The short musical fanfare plays one minute
before the auto-shutoff occurs. Press any button on the RF
remote control to resume melody play and reset the timer.
Color
lenses
baby
einstein
™
button
OFF
Play
Mode
Try-Me
Mode
OFF – Turns OFF the electronics in the unit and
resets the timers for the music and lights.
Try-Me Mode – For in-store demonstrations;
designed to conserve battery life. Press the baby
einstein™ button to activate the music mirror unit.
Play Mode – For RF remote control operation of the
music mirror. This is the normal operating mode.
RF Remote Control
Press any of the four buttons to control the music mirror unit.
Music Play Button – Press to start a randomly
selected melody. Dancing lights in the color
lenses accompany the music. Press the Music
Play Button during any melody to pause the
music. Press again to resume music with the next
melody.
The music mirror unit plays the song list twice and stops.
(See song list in next section.) Press the Music Play Button
again to restart the melodies.
Learning Colors Button – Press this button to
to begin a color learning program. It covers
English, Spanish, and French color names for
each of the five color lenses on the music mirror
unit. The learning program is in two parts:
1 Part 1 – A five-color lesson for each language: The
music mirror unit will say each of the five color names in
English while lighting the corresponding color lens. A
short melody follows each color name, and the color
lenses dance to the music (pulse in order, left to right).
The color lesson is repeated in Spanish and then again in
French.
2 Part 2 – One five-color lesson, combined languages: The
music mirror unit will say each of the five color names in
English, Spanish, and French in succession. The corre-
sponding color lens illuminates for each color. A melody
follows each color name, and the color lenses dance to
the music (pulse in order, left to right).
Lights Enable/Disable Button – Press this
button to disable the lighted color lenses during
Music Play operation. This function allows
music-only operation for nighttime driving.
NOTE: The lights cannot be disabled during the Learning
Colors Program (works only during Music Play).
Volume Control Button – Press this button to
change the music volume. The settings alternate
among low, high, and mute. Use mute when you
need lights-only operation without interrupting
the play sequence of the music mirror unit.
Front Panel Control
Use the baby einstein™ button for basic operation of the
music mirror unit or when the RF remote control is not
available. Press the button once to play all the melodies on
the song list. After the last melody plays the colors learning
program begins. The learning program includes both parts as
described in the previous RF remote control section.
color
s
couleurs
color
es
Music Play
Learning
Colors
Lights
Enable/
Disable
Volume
Control
colors
couleurs
colores