Baby Jogger city premier Assembly Instructions Manual - page 10
10
FRAME
1 Unpack the stroller frame from the box
and set the wheels aside.
Unlock the stroller by pulling the
Storage
Lock Lever.
2 Lift the Handlebar away from the lower
frame. The stroller will click into place.
3 Place the stroller in the upright position.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
4 Installation
• Lay stroller on its back so the
Handlebar is resting on the floor.
• Attach the Front Wheel by sliding it
into the front wheel mount until it
clicks. Gently pull on the Front Wheel
to make sure it is properly attached.
5 Removal
• While pressing the front wheel release
button, gently slide the Front Wheel
out of the front wheel mount.
SWIVEL FEATURE
6 Press the Swivel Lock button down
and slide the Swivel Lock to the left to
lock the front wheel assembly in a fixed
position for long distance strolling.
7 Press the Swivel Lock button down
and slide the Swivel Lock to the right
to allow the front wheel assembly to
swivel.
WARNING: When loading and
unloading child, lock the front wheel in
a fixed position. Although the
front wheel of your stroller locks, it is
not intended for jogging or exercise
purposes.
REAR WHEELS
8 Installation
• Align the Rear Wheel axle with the
wheel mount on the stroller frame
and insert it into the wheel mount
until it clicks into place.
• Gently pull on the Rear Wheel to
make sure it is properly attached.
9 Removal
• While pressing the Wheel Release
Button, gently slide the Rear Wheel
out of the wheel mount.
BRAKE
10 To Lock the Brakes: gently pull the
Brake Lever into upright position until it
clicks into place.
11 To Release the Brakes: Pinch the gray
tabs and pull the lever towards you.
Push the Brake Lever down until it is
parallel with the frame.
WARNING: Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving.
SEAT - UNFOLD THE SEAT
12 Holding the footwell and the top of the
seat, open the seat.
13 The seat will lock into its open position.
CANOPY
14 Attach the canopy to the frame: Attach
the Canopy’s brackets to the sides of
the seat frame.
15 Attach the 3 fastening strips on the
canopy to the top of the seat.
ADJUSTING SAFETY HARNESS
16 Holding the shoulder strap and plastic
guide, slide the guide down to shorten
the harness height or slide the plastic
guide up to increase the harness height.
WARNING: Avoid serious injury from
falling or sliding out. Always properly
adjust and fasten safety harness.
WARNING: Always use the crotch strap
in combination with the shoulder straps
and waist belt.
17 Hold the plastic guide and pull the
lower shoulder strap end to tighten or
pull the upper shoulder strap end to
loosen.
18 Hold the plastic guide and pull the front
waist strap end to tighten or pull the
rear waist strap end to loosen.
19 Hold the plastic guide and pull the
lower crotch strap end to tighten or pull
the upper crotch strap end to loosen.