Baby Jogger Q-SERIES TRIPLE Assembly Instructions Manual

Summary of Q-SERIES TRIPLE

  • Page 1

    Important, keep for future reference assembly instructions amazing quick folding system (patented) q-triple q-triple (assem) 4/6/05 2:09 pm page 1.

  • Page 2

    2 • important, keep this booklet for future reference. • accessories which are not approved by the manufacturer or distributor should not be used. • warning: prevent serious injury to your child by always using the safety harness. • warning: any load attached to the handle affects the stability of t...

  • Page 3

    1 frame • to assemble, simply unfold frame as shown. 1 2 3 4 q-triple (assem) 4/6/05 2:09 pm page 1.

  • Page 4

    2 1 to install front wheels, lay jogger back so handle is resting on floor. Open the caliper by flipping the caliper lever toward the rear wheels. 2 insert one of the front wheels into the fork tips by aligning the axle flats with the fork tip flats. 3 tighten by turning the wheel lever while holdin...

  • Page 5

    3 • to install, gently slide the wheel’s rear axle into the hole in the axle end until you hear it click into place. • to remove, simply push in the spring lock while pulling out the wheel. Rear wheels q-triple (assem) 4/6/05 2:09 pm page 3.

  • Page 6

    4 • if you don’t have good braking action, simply squeeze the brake handle five or six times. If the problem persists, loosen the brake’s cylinder ring to adjust the small ring, and then move the small ring away from the handle to tighten the cable. (please do not over tighten!) to lock the rings, t...

  • Page 7

    5 adjusting safety harness: 1 loosen the shoulder straps from their plastic guides. 2 slide the end of each strap through pair of seat loops closest to your child’s shoulder. 3 slide the end of the shoulder strap back into plastic guide.Please note: if you feel the straps are too tight, you may adju...

  • Page 8

    6 1 simply adjust seat straps to desired degree of recline. 2 pull on strap when you want to return the seat to its upright position. 3 rear flap serves as sun canopy when seat is in reclined position. Reclining seat 4 jogger is packaged with seat support board and can be easily removed or inserted ...

  • Page 9

    Folding simple lift & fold yellow safety straps must be released before folding 7 1 retract sun canopies and unsnap the yellow safety straps from jogger frame. 2 stand in front of the jogger with your body centered over one front wheel. Grasp both fold straps and firmly pull upwards to fold. Always ...

  • Page 10

    8 seat 1 snap seat to frame. 2 attach bottom part of seat to footplate with the velcro. 3 wrap bottom straps around frame, thread each strap through d-ring and secure. 5 snap all center yellow safety straps to jogger frame. 6 snap safety strap to side frame. 4 standing behind stroller, locate the ce...

  • Page 11

    9 always be sure the yellow safety strap is securely snapped onto the frame before using jogger! 7 thread folding straps through openings in each seat. 8 attach folding strap to folding trigger and secure the triangle shaped fastener. Q-triple (assem) 4/6/05 2:10 pm page 9.

  • Page 12

    10 1 snap front basket straps to frame tube. Basket 2 wrap rear basket straps around upright and snap back to itself. Note: the rear of basket has the mesh material and the front doesn’t. Q-triple (assem) 4/6/05 2:10 pm page 10

  • Page 13

    4 now secure velcro tabs of center of canopy around both center bar on jogger frame. 3 at the top corners of the sun canopy there should be two velcro straps, snap the canopy straps to the frame and velcro it back to itself. 2 thread both canopy brackets through the seat’s center hole and secure to ...

  • Page 14

    12 steering • steering your jogger is simple: it’s balanced to turn with just a light touch on the handlebar. For tighter turns, push down on the handlebar and raise the front wheel to steer. Wrist strap • make sure wrist strap is around your wrist whenever your baby is in the jogger. The baby jogge...

  • Page 15

    13 washing • you can machine wash your jogger’s seat in cold water with a mild detergent. To minimize shrinkage, simply reattach the seat to the frame to dry. (please do not put the seat in the dryer!) • be sure to remove the board from the back of the seat before washing. • you may clean the jogger...

  • Page 16

    We wish you many happy journeys with your new baby jogger! Your jogger is a great product, and we are proud to manufacture it. If you have any questions or comments, please give us a call at. Bjc qt 4/05 1.800.241.1848 baby jogger is a division of dynamic brands 8575 magellan parkway, suite 1000 • r...