Baby Lock BL J18-QM Installation Manual - page 42
of
66
Pg. 41
I . Turn your QuiltMotion Plate upside down as
shown in Fig. A.
II . Unplug the cable coming from the control box
as shown in Fig. B.
III . Remove the lid of the control box and slide
out the Crown Jewel Slider Board (designated with
a “CJ”) from the control box. Slide the Jewel Slider
Board (designated with a “J”) into the control box
as shown in Fig. C and Fig. D.
IV . Replace the cover of the Control Box and plug
the cable back in as shown in Fig. E.
Changing Jewel Slider Board
Parts Needed:
1- QuiltMotion Plate
1- Crown Jewel Slider Board
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E