Baby Lock Endurance II BND9-2 Instructions

Copyright 

 2004-2013 Baby Lock USA 

Customer Support: 1-800-313-4110 

BND9-2 Ver. 4.21 Software Update 

– p.1 

Baby Lock Endurance 2 

(Model BND9-2) 

Software Update Version 4.21 

December, 2013 

Introduction 

If the software version of your BND9-2 is earlier than Version 4.21, an update program is now 

available for download to improve its performance. 

Version 4.21 update will provide the following changes: 

1.  Fixed the situation where the LED pointer was not turned on when moving the needle back using 

the Forward/Backward Stitch Key after the error message for checking the upper or bobbin thread 

was displayed 

2.  Fixed the situation where the machine may not work correctly after the error message was 

displayed by selecting the appliqué setting. 

3.  Improved so that the embroidery pattern moves by 0.1 mm when the arrow keys are pressed on the 

pattern editing screen. 

When you press and hold the arrow keys, the pattern moves by 5 mm. 

To confirm the software version of your BND9-2 

1.  Press the power switch to turn on your machine. The LCD screen comes on. 

2.  Touch anywhere on the initial screen and then touch “OK”. 

3.  Touch 

 (Settings key) at the bottom of the LCD display. The Settings screen appears. 

4.

  Switch screens by using 

 (Previous page key) or  

 (Next page key) to display the 

software version.