Baby Trend Close N Cozy Instruction Manual - Assembly
Copyright © 2008 - 2009, Baby Trend Inc., All Rights Reserved.
Copyright © 2008 - 2009, Baby Trend Inc., All Rights Reserved.
ASSEMBLY
ASSEMBLY
STEP 8:
Connect the lower BACK to the frame corners by
slightly spreading the side frames and inserting
the bar into holes. Then connect the lower FRONT
bar. Secure the Front and Back Bar using the
screws provided. (Fig. 8)
Note: The holes in the bar and the housing must
line up in order to insert the screws and properly
connect.
STEP 9:
Connect the soft goods to the frame by turning
the frame over and zipping closed all three (3)
zippers.
STEP 10:
Insert the mattress support bars by sliding one end
of the bar through the pocket and back through the
opposite side. (Fig. 9)
Note: Do not use this product without the support
bars securely in place.
STEP 11:
For stand alone
Insert mattress and position mattress
in place. (Fig. 10)
For playard w/Close N Cozy accessory
Using the full size playard mattress, fold in half
and insert mattress with fastening strips facing
front side of bassinet. Feed fastening strips
through provided slots and secure the strips to
velcro located on the bottom of the bassinet.
(Fig. 11)
Your Close N Cozy bassinet is now ready to use.
FALL HAZARD:
NEVER
place Close N Cozy bassinet on an
uneven or elevated surfaces.
Fig. 9
Fig. 8
WARNING:
SUFFOCATION HAZARD:
NEVER place pillows, quilts,
comforters, sheepskins, pillow-like
stuffed toys and other pillow like
products in the Close N Cozy bassinet.
IMPORTANT!
Cover
infant with a thin covering, such as
a crib blanket, receiving blanket or
other blankets specifically designed
for infants, only reaching as far as
baby's chest, and tuck the covering
around the mattress.
Attach Close N Cozy to
playard
ATTENTION:
Before installing Close N Cozy bassinet, remove
ALL accessories from playard. (Canopy, bassinet,
changing table, mobile and music box.....)
Hold Close N Cozy bassinet over playard. Line
up the frame corners over the top rails of the
playard and push firmly downward. Make sure
all four frame corners are attached to the playard's
top rails (Fig. 12).
ATTACH SIDE BASKET TO PLAYARD
If you have Type A or Type C, skip this step.
Type B: Soft Cover with Side Basket
Place Close N Cozy bassinet near the playard
frame corners that the changing table attaches to.
Zipper side basket in place. Fold snap flap over
the side of the playard and firmly secure. Snap
the remaining snap flap on the Side Frame Bar
(Fig. 13).
Side basket can also be attached to the playard as
shown in Fig. 14.
Fig. 11
Fig. 10
7
8
Fig. 12
Fig. 13
Fig. 14