Baby Trend HB40A Owner's Manual - Warning!
21
22
Copyright © 2016, Baby Trend, Inc.
Copyright © 2016, Baby Trend, Inc.
3. Place the car seat on the vehicle seat in a location equipped with
a Lap/Shoulder Belt and centered between the Lap/Shoulder belt
anchorages (see “Selecting a Vehicle Seating Locations” section).
To secure car seat and your child:
1. Remove seat back support (see “Assembly
and Removal for Back Support” section on
page 24).
2.TheShoulderBeltPositionerwillbeaffixed
to the yumi and stored under the soft goods.
Locate belt positioner; store under soft goods.
6.0 Installation and Use
•DonotplacetheBacklessBooster
Car Seat in a seating position that has
onlyavehiclelapbelt.
4. If the vehicle seat back is adjustable, adjust
into the upright position or the position
specifiedinthevehicleowner’smanualfor
use with a car seat.
5. Place child in Backless Booster Car Seat
withchild’sbackandrumpcontactingseating
surfaces.
WARNING!
6. Place lap and shoulder belt across front of
child and buckle seat belt.
- Position lap belt under both lap belt guides.
-Placeshoulderbeltoverchild’schestand
into lap belt guide closest to auto buckle.
NOTE: Armrest may be raised to make getting in
Booster easier. Be sure to lower armrest
once child is seated in booster seat.
7. Place vehicle shoulder belt in Vehicle
Shoulder Belt Positioner and adjust to position
shoulder belt on child.
- Thread harness strap through Vehicle
Shoulder Strap Positioner as shown.
- Pull up or down on the webbing adjuster until
the vehicle shoulder belt is centered over the
child’sshoulder.
- Check to be sure vehicle shoulder belt is
properly positioned over shoulder and snug
against child.
6.0 Installation and Use
NOTE: Some vehicle shoulder belts with emergency locking retractors
allow child to pull belt out and change position of belt. Use
of Shoulder Belt Positioner helps maintain proper position of
shoulder belt.