Baby Trend Navigator Instruction Manual - Warning:
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
5
6
Fig. 8
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 9a
Fig. 9b
Snap
Insert Screws
Fig. 10
Fig. 11
Open
Close
REAR WHEELS
Lean the stroller forward to rest on the front
wheel. To attach the rear wheels, push each
wheel's axle into the plastic corner fitting as
shown in Fig. 8. Depress the metal lever on the
inside of the corner fitting as you push the axle
into corner fitting. When the wheel will not go
on any farther, release the lever. Check that the
wheel has locked into the corner fitting by pulling
on the wheel. If not locked, lift upward on the
lever, push the wheel on farther and release lever.
Ensure that the wheels are firmly locked
into place.
NEVER
use the stroller if the
wheels are not locked into place, contact our
customer service department immediately at
1-800- 328-7363, between the hours of 8:00am
and 4:30pm PST, for assistance.
PARENT TRAY
To attach the parent tray, position the parent tray
in the center of the stroller handle.
• Snap the upper portion of the tray over the
handle as shown in figure 9a.
• Attach the lower portion of the parent tray to
the cross tube, with the screws provided, as
shown in figure 9b.
WARNING:
Do not place
hot liquids or more than 3 pounds
in the parent tray. Serious burns or
unstable conditions could result.
CANOPIES
To open the canopy: push forward on the front
edge of the canopy. (Fig. 10) Push downward on
the tensioners to secure.
To fold the canopy: pull upwards on the
tensioners and then pull backwards on the front
edge. (Fig. 11)
ASSEMBLY
CHILD TRAYS
To Attach the child trays:
Push the tray downward onto the pegs on each
side of the front armrests until both sides snap into
place. (Fig. 12) Check that the tray is scurely
latched in place.
To open the child tray:
Pull the release lever located on the underside of
the child tray and lift upward.
Your stroller is now ready to use.
INFANT CAR SEATS (if equipped)
WARNING:
Never jog or
run with your newborn in the car
seat position. Use for strolling only.
IT IS VERY IMPORTANT THAT THE
INFANT CAR SEAT STRAP IS ALWAYS
TIGHTLY FASTENED AROUND THE
INFANT CAR SEAT.
To attach Baby Trend Infant Car Seats:
• Recline the seat all the way back
• Position the infant car seat facing toward the
rear of the stroller so that the shell goes onto
the tray and latches into place. (Fig. 13)
• Check that the front child tray is firmly
attached to the stroller. Make sure that the car
seat locks into the child tray.
• Strap the short clips over the car seat through
the seat belt slots on the infant car seat.
(Fig. 14)
To remove infant car seat:
Squeeze the release handle located at the the foot-
end of the infant car seat and carefully lift upward.
(Fig. 15)
ASSEMBLY
Locks
into tray
Child tray
Short clip