Baby Trend TREND WALKER 3635 Instruction Manual - Assembly

2

ASSEMBLY

PARTS

1.  Unpack all contents and please check that all parts are present before      

 starting assembly.  Please see PARTS.

2.  To open the baby walker raise the tray to the middle position as shown in       

 figure 1.

3.  Insert the plastic pins on the front of the seat into the holes, then click the 

pins into position by pushing them downwards shown in figure 2.

4.  Locate the straps with plastic buckles on back of seat and corresponding 

slots on tray. Insert each strap into corresponding slot. From underside of 

tray pull each strap completely through each slot and pivot plastic buckle 

to lay flat against underside of tray. As shown in figure 3 and 3A.

5.  Place  walker  on  a  solid  flat  surface  with  bottom  of  base  facing  upward. 

Insert the pins of the wheels into their housing, pressing them until they 

snap into position. Please check that wheels are locked into place as shown 

in figure 4 and 5.

6.  Thread the end of the support strap through the loop on the seat bottom and 

then  through  the  slot  at  the  end  of  the  height  adjustment  bracket  found 

under the tray as shown in figure 6. Next thread the support strap through 

the opening in the rectangular ring and pull snug as shown in figure 7.

Fig. 1

Fig. 2

Toy Bar

Seat

Wheels

front

rear

Fig. 4

Fig. 3

Fig. 3A

Fig. 5

Fig. 6

Fig. 7

FRONT 

REAR 

Base