BabyLove Aurora Instruction Manual - page 3
10
www.babylove.com.au
CLEANING
• To clean vinyl and metal parts wipe with a clean wet cloth and a mild soap and
water solution.
• To clean woven fabric use upholstery cleaner such as normally used on furniture or
a mild soap and water solution. Allow fabrics to air dry, out of direct sunlight.
• Never clean with abrasive, ammonia based, bleach based or spirit type cleaners.
CARE AND MAINTENANCE
• Check the main components and other parts operate freely and are secure. Check
regularly for wear & tear, loose fasteners and damage. Tighten any loose fasteners.
Replace any worn or damaged parts immediately using only Babylove approved
parts.
• Moving parts may require occasional lubrication with a dry lubricant or a silicon
based spray lubricant. This will help to avoid squeaks.
• Exposure to direct sunlight will fade most fabrics over time. To limit the effect of UV
fading, avoid leaving the stroller in direct sunlight where practical.
MODEL VARIATIONS
• Note that the fabric patterns and colours pictured on the stroller in this instruction
manual may vary from that of the product that you have purchased.
03
www.babylove.com.au
1. TO FIT & REMOVE THE ARMBAR
WARNING: When a child is in the stroller, keep the armbar
attached to the frame at all times. Do not lift stroller by
armbar as it may disengage.
A.
Locate the pins one by one into each moulding on the
front of the stroller. Push in one at a time until they are
locked into the moulding. Pull on each to confirm. Repeat
until you hear them click in. Press in the armbar release
buttons to assist with installation if necessary.
B.
To open for easy child entry and exit. Push the button in
and release the armbar on one side.
To remove the armbar, press the release buttons and pull
the armbar to disengage.
2. TO OPEN THE STROLLER
A.
Hold the stroller by the handle and release the storage
latch. Lift the handle up. The stroller legs will now drop
open. Sit the frame on a flat surface.
B.
To lock the frame in the open position. Hold the handle
with one hand and then push down on the armbar.
Both handle and leg tube mouldings should lock
together. Check that both sides of the frame are locked
together. Repeat if not locked. Push down on the handle
to confirm frame engagement.
A
A
B
B
A