Oxor ii instruction 19-9126 portable oxygen analyzer part no. 19-7037 & 19-7044 rev. 6 – october 1999 ® bacharach, inc. 621 hunt valley circle, new kensington, pa 15068 ph: 724-334-5000 • fax: 724-334-5001 • web: www.Bacharach-inc.Com e-mail: help@bacharach-inc.Com printed in u.S.A. ® registered tra...
Warranty bacharach, inc. Warrants to buyer that at the time of delivery this product will be free from defects in material and manufacture and will conform substantially to bacharach inc.’s applicable specifications. Bacharach’s liability and buyer’s remedy under this warranty are limited to the rep...
1 warning! Because this instrument is used to detect and monitor materials and conditions which are listed by osha or others as potentially hazardous to personnel and property, the information in this manual must be fully understood and utilized to ensure that the instrument is operating properly an...
2 figure 2. Battery installation to prepare the instrument for operation, you must install four “c” size batteries, and (if desired) install the hose and probe as described in the following paragraphs. For your convenience, and to ensure that the instrument will provide reliable o 2 indications, the...
If batteries are accidently installed in the wrong polarity, a positive temperature coefficient (ptc) thermistor will protect the instrument’s electronic circuitry. The instrument will operate once batteries are properly installed and the ptc thermistor is allowed to cool. 3.2 probe installation ins...
4 4 operation to operate the oxor ii, you simply . . . • set its power switch to on, • wait for the instrument to warm up (approx. 1 minute), • span the display (if necessary), • take a gas sample. Detailed operating procedures are presented below: 4.1 power on/off turn on the instrument by sliding ...
5 4.6 interpreting the display gas display the lcd directly shows o 2 levels in the range from 0 to 25%. The display on the right indicates a o 2 level of 20.9%. 4.4 using the strap the instrument's elastic strap allows the unit to be either hand-held, or hung on nearby objects. By sliding your hand...
6 low battery indications when the battery voltage becomes low, the “lo bat” indicator appears. Although the instrument will continue to operate and give percent o 2 read- ings under these conditions, the batteries should be replaced as soon as possible. When the battery voltage becomes too low for ...
6 parts/service 6.1 parts list item part no. Battery cover 19-3029 basic probe/hose assy. 19-3086 optional probe/hose assy. 19-3076 6.2 bacharach sales/service centers 7 united states bacharach, inc. 621 hunt valley circle new kensington, pa 15068 phone: 724-334-5051 fax: 724-334-5723 e-mail: help@b...
Notes: 8.
