Bacharach DRAFT GAUGE Instruction

Page of 5

Download

Bookmark us

WARRANTY

Bacharach, Inc. warrants to Buyer that at the time of delivery this Product

will be free from defects in material and manufac ture and will conform

substan tially to Bacharach Inc.’s applicable specifi cations. Bacharach’s

liability and Buyer’s remedy under this warranty are limited to the repair

or replacement, at Bacharach’s option, of this Product or parts thereof

returned to Seller at the factory of manufacture and shown to Bacharach

Inc.’s reason able satisfaction to have been defective; provided that written

notice of the defect shall have been given by Buyer to Bacharach Inc.

within one (1) year after the date of delivery of this Product by Bacharach,

Inc. For full details concerning this warranty, contact Bacharach Inc.

DRAFT GAUGE

Instruction 0013-9009

Rev. 5 - May 2010

World Headquarters

621 Hunt Valley Circle, New Kensington, PA 15068

Ph: 724-334-5000 • Fax: 724-334-5001 • Toll Free: 800-736-4666

Website: www.mybacharach.com • E-mail: help@mybacharach.com

Printed in U.S.A.

®Registered Trademark

Page 1
Warranty bacharach, inc. Warrants to buyer that at the time of delivery this product will be free from defects in material and manufac ture and will conform substan tially to bacharach inc.’s applicable specifi cations. Bacharach’s liability and buyer’s remedy under this warranty are limited to the ...
Page 2
2 figure 1. Draft gauge mounting the instrument for portable use stand the gauge on a reasonably level surface convenient to the location for checking draft. Gauge may also be hung in an upright position using Ë(slotted recess) to receive a nail or screw head. For permanent installation remove Ì (sc...
Page 3
Figure 2. Draft gauge parts 5 4 parts list for the draft gauge 0013-0014 scale +.05 –.25” h 2 o 0013-0015 scale +.05 –1.0” h 2 o 0013-0016 scale +1 –25mm h 2 o 0013-0017 scale +1 –5mm h 2 o 0013-0159 scale +1 –15mm h 2 o 0013-0056 leaf spring assembly for +.05” –.25” or +1 –5mm h 2 o range 0013-0057...
Page 4
Locations for checking draft furnace manufacturer may require measurement of draft (a) in fl ue between regulator and furnace or (b) overfi re between com- bustion space and heat exchanger (figure 4). Locate sampling hole in fl ue 6” or more from draft regulator or damper toward furnace. Use awl wit...
Page 5
8.