Bacharach HGM300 Installation Manual - page 2
Other manuals for HGM300:
Technical Maintenance Manual, Installation Manual, Product Catalog, Technical Note, Installation, Operation & Maintenance Instructions Manual, Installation & Operation Manual
Manual is about: Refrigerant Gas Monitoring System
of
10
The adapter board mounts on the rear of the HGM300 door. Position the adapter board
so as not to interfere with the HGM internal components when the door is shut. Mark
(Figure 1) and drill the board’s four corner holes and center hole in the door. Install the
five standoffs on the rear side of the door using the five black decorative screws on the
front side of the door. Position the adapter board over the standoffs mounted on the
HGM door. Install the five remaining 6-32 screws through the board and into the
standoffs and tighten.
Connect power wiring from the HGM300’s 120V Auxiliary Power terminal block to the
adapter board’s POWER terminal block. Use UL approved wire. Wire polarity does not
matter.
2 of 10