Back to Basics SMOOTHIE SIGNATURE SALPHA500 Instruction Manual - page 4

A

SSEMBLING 

Y

OUR 

S

MOOTHIE 

S

IGNATURE

™

Before assembling your Smoothie Signature

™

 wash all parts, 

except for the motor 

base in warm, soapy water, rinse thoroughly and dry.  Unscrew and disassemble the 

valve for cleaning (see Cleaning Your Smoothie Signature

™

 section).  To prolong the 

life of your smoothie maker, 

do not wash parts in the dishwasher. 

1.  Position the rubber gasket down onto the circular flat surface in the blade base. 

2.  Screw the blade base onto the bottom of the blending jar by twisting the blade 

base counter-clockwise until tightened.  Make sure that the blade base is tightly 

fastened to the blending jar and that the rubber gasket is properly compressed 

between the blending jar and the blade base. 

3.  Press the lid onto the top of the blending jar.  Press the clear lid cap in the 

center of the lid or place the stir stick through the center of the lid if blending 

liquids or frozen drinks. 

4.  Place the blending jar onto the motor base so that the bottom of the blade base 

is sitting flat on the motor base. 

5.  Plug in the cord.  Your smoothie maker is now ready to use. 

Stir Stick 

Lid Cap 

Lid 

Blending Jar 

Dispensing Valve 

Blender Cap 

Rubber Gasket 

Blade Base 

Motor Base 

4