Backyard Creations 98300 Assembly Instructions Manual

Summary of 98300

  • Page 1

    1 assembly instructions warning do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. An lp-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance. Danger if you smell gas: 1. Shut off gas to the ...

  • Page 2: Table of Contents

    2 table of contents important safety information 3 important about propane 4 specification 4 parts identification list 5-6 installation 7-11 natural gas conversion 12 lighting instructions 13 batteries 14 maintenance 14 troubleshooting guide 15 warranty 16.

  • Page 3

    3 important safety information the installation must conform with local codes or, in the absence of local codes, with the national fuel gas code, ansi z223.1/nfpa 54; international fuel gas code. ; natural gas and propane installation code, csa b149.1; or propane storage and handling code, b149.2, a...

  • Page 4: Propane (Lp) Gas

    4 important safety information about propane (lp) gas a self contained lp-gas cylinder for use with this appliance must have a capacity of 20 lbs. And must be equipped with a type 1 connector and an opd (overfill protection device). See figure 1. The lp-gas supply cylinder to be used must be constru...

  • Page 5: Parts Identification List

    5 parts identification list part description part# qty a control knob fp0245 1 b gas valve fp0307 1 c thermocouple fp0004 1 d lp regulator hose fp1329 1 e electrode fp1330 1 f gas tube fp1689 1 g orifice elbow fp1385 1 h ignition module fp1666 1 i orifice bracket fp1667 1 j propane orifice fp1299 1 ...

  • Page 6

    6 t middle panel fp1673 1 u bottom panel fp1674 1 v back panel fp1675 1 w door panel fp1676 1 y burner cover fp1677 1 z burner cover protective ring fp1678 1 aa firepan/burner assembly fp1679 1 bb support bar-1 fp1680 1 cc support bar-2 fp1681 1.

  • Page 7: Installation

    7 installation 1. Identify parts packed in carton against the parts list. Remove all protective materials and set parts on a flat, non-abrasive surface. Important note: we recommend two people work together to assemble the product. 2. Place the back panel upside down on a flat, non-abrasive surface....

  • Page 8

    8 4. Attach the bottom panel to legs by using four 1/4"x30 mm bolts and washers as shown in figure 4.Guide the bolts through holes in the bottom panel, into pre-drilled holes in the legs. Hand tighten only. Figure 4 5. Carefully place the middle panel inside back panel with bottom panel as shown in ...

  • Page 9

    9 6. Attach the bottom panel to the back panel by using two 1/4"x30 mm bolts and washers as shown in figure 6. Guide the bolts through holes in the bottom panel, into pre-drilled holes in the back panel. Hand tighten only. Figure 6 7. Attach two support bar to the firepan/burner assembly by using tw...

  • Page 10

    10 9. After making any necessary adjustments to the alignment of the all parts, use the hex bolt driver to tighten all bolts. Do not over tighten. Over tightening may strip bolts. 10. With the help of another person, attach the table top to the complete base by using four 1/4"x18 mm bolts and washer...

  • Page 11

    11 12. Tighten threaded knobs (l) found on tank tray (figure.11) ) so that the lp tank cannot move from side to side. Do not remove plastic cap from end of threaded section. Figure 9 13. Pour the lava rocks(not include) into the burner pan completely covering the burner. See figure 12. Burner pan ig...

  • Page 12: Natural Gas Conversion

    12 natural gas conversion natural gas conversion must be performed only by your natural gas provider or service company. Step 1- at the control panel, disconnect the rubber gas hose from the gas valve. Step 2- below the burner, disconnect the aluminum gas tube from the orifice elbow. Step 3- remove ...

  • Page 13: Lighting Instructions

    13 step 5- stick the conversion label on the rating plate as shown in figure 15. Metal rating plate 1. 2. 3. 4. 5. 6. 7. Figure 15 conversion label lighting instructions warning: if these instructions are not followed exactly, a fire or explosion may result causing property damage, personal injury o...

  • Page 14: Batteries

    14 control knob in for 10 to 15 seconds. Release the control knob. The control knob should pop back out and then remain lit. Note: if the fire does not light, turn the knob to the “off” position and wait five (5) minutes before trying again. 3. To turn down the flame, push the control knob in slight...

  • Page 15: Troubleshooting Guide

    15 troubleshooting guide problem cause remedy no propane gas at burner check that gas tank valve is open. Turn control knob to “on” and push control knob in. Make sure tank has propane gas. No spark at electrode check that aaa battery is installed with negative (-) end first and has a charge. Check ...

  • Page 16: One-Year Limited Warranty

    16 one-year limited warranty what is covered under this warranty? The item you have purchased is warranted against defects in material and workmanship for the following parts from the date of purchase for the period of warranty as outlined below, but only when the unit is installed and operated in a...

  • Page 17

    17 that limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state..