Badger Basket 00750 Pink Waffle Assembly Instructions Manual

Summary of 00750 Pink Waffle

  • Page 1

    3.0/1108/tg model numbers: t-series portable baby bassinet ‘n cradle with toybox base assembly instructions. Adult assembly required. Save these instructions for future use. Visit us online at www.Badgerbasket.Com toll-free customer service: 1-800-236-1310 (monday through thursday 7:30 am to 4:30 pm...

  • Page 2: Before You Begin Assembly:

    3.0/1108/tg before you begin assembly: check all parts and hardware. If anything is missing or not satisfactory, please do not call the store where purchased or return the product to them. Contact badger basket for assistance. Most problems are resolved without you needing to leave home. When contac...

  • Page 3: Parts & Hardware:

    3.0/1108/tg tools needed: phillips screwdriver* * power screwdriver is helpful but be careful not to damage the product page 3 of 6 parts included (pictures not to scale): (a) 2 - end panels (note inside and outside faces) (b) 4 - rails (c) 8 - bolts (d) 2 - nylon snap straps (e) 2 - dowels (f) 1 - ...

  • Page 4

    3.0/1108/tg step 1: see picture 1. Take one end panel (a) and attach the four rails (b) using four bolts (c). Attach the rails to the inside face of the end panel. The inside face has countersunk areas for the rails and slots that you will use later for the mesh basket. Position the bottom rails wit...

  • Page 5

    3.0/1108/tg step 5: unpack the bedding set (i). You may launder the set be- fore use if you wish, and/or iron, press, or steam it to remove wrinkles. Machine wash cold, gentle cycle only; air dry or tumble dry low or no heat. Iron on lowest setting for poly/ cotton. Locate the buttonholes on the fab...

  • Page 6: Picture 8

    3.0/1108/tg page 6 of 6 picture 7 to use the bassinet as a rocking cradle, loosen the caster knobs, rotate the casters into the up position, and retighten the knobs. See picture 7. Step a: remove the bedding, bassinet body, hood, wooden dowels, and mesh basket, and set them aside. Step b: unscrew an...