Model 155 instruction book u.S. Patent #5,779,157 tm tm.
2 at badger air-brush co. We are extremely proud of our people and our products. Our continued growth and success is based upon high quality and conscientious craftsmanship in the manufacture of each and every badger product. At badger air-brush co. There is a feeling of accomplished pride and dedic...
3 learn to trigger best results are achieved with the ™ by airbrushing with a good constant motion. Start motion before pressing trigger, follow through motion after releasing trigger. Do not hesitate while spraying or you will create what is called the barbell effect. Maintenance and cleaning of yo...
4 place the new tip into its seat in the airbrush body (see photograph 1), and then screw the head and spray regulator onto the airbrush body. The head assembly on the model 155 ™ is designed to be tightened firmly by hand – use of pliers or other tools should not be necessary! Before spraying, rese...
5 51-073 41-033† 41-034 51-071 41-004 41-003† 50-046 51-085 51-075 51-069 51-043 51-048 51-048dt† 50-030 50-044 50-031 51-010 50-0482 50-0052 50-013 50-0141 50-014 50-020 50-015 50-036 50-042 50-019 exercise one/free hand controlled effect the exercise shown in fig. 1 is accomplished by practicing t...
6 masking off in the next several exercises you will need to mask off a square area. Make a mask from 4 pieces of scrap paper (fig. 8). These masks are held in place by masking tape, keeping the atomized material from creeping into the margins around the area. When using masks spray over the edge. F...
7 techniques to use masking or frisket is used mostly to create a sharp edge or when more than one color is applied. A new frisket is cut for each color and covers any area that should not be sprayed. Badger’s foto/frisket ™ film is specially formulated for use on all surfaces commonly used for airb...
Effect is desired. 8) bubbles through the color cup. The spray regulator might be turned out too far, or the head may be loose. Check both and tighten if necessary. 9) color spray cannot be shut off. Tip may be clogged. This is recognized by a “spongy” feel when needle is set into tip. Remove the he...
