Rdm-um-01089-en-06 (september 2014) recordall® industrial meters nutating disc meter user manual.
Recordall® industrial meters, nutating disc meter contents description 3 operating principle 3 unpacking and inspection 4 installation 4 general operating instructions 5 manual operation 5 accessory controlled operation 5 shutdown instructions 5 maintenance 6 preventive maintenance 6 calibration che...
Description description the badger meter recordall (rcdl) positive displacement meters are one of the most cost effective methods in metering industrial fluids the rcdl meter has a simple, efficient design for high accuracy and repeatability over the entire meter flow range available in five sizes, ...
Unpacking and inspection unpacking and inspection upon receipt of meter, perform the following: otee: n if damage to the shipping container is evident, request the carrier to be present when meter is unpacked 1 carefully open the shipping container remove all the cushioning material surrounding the ...
General operating instructions excess gap length may cause excessive strain on connection assemblies. C remove the connections and install one connection piece in each end of the facility pipe gap provided in step 4b allow for the gaskets at the inlet and the outlet spuds of the meter d install the ...
Maintenance maintenance preventive maintenance preventive maintenance consists of periodic inspection and cleaning procedures perform the procedures at regular intervals and correct any defects before resuming operation of the meter periodic inspection 1 visually inspect the meter and teh accessory ...
Maintenance change-gear calibration if the accuracy test of a meter-accessory combination indicates that an adjustment is required and change-gears are the medium for calibration, proceed as follows: 1 remove applicable driver (accessory) change-gear and driven (meter) change-gear otee: n the number...
Electronic calibration if electronic scaling is the accessory medium for calibration, see the accessory technical brief for instructions servicing the following instructions are for removal, inspection and installation of meter parts and assemblies refer to applicable illustrated parts list for part...
