- DL manuals
- BAFANG
- Engine
- MAX Drive System
- Dealer's Manual
BAFANG MAX Drive System Dealer's Manual
Summary of MAX Drive System
Page 1
Dealer manual max drive system en suzhou bafang electric motor science-technology co., ltd no. 9 heshun rd suzhou industrial park 215122, suzhou china bf@szbaf.Com www.Szbaf.Com.
Page 2: Content
Dealer manual max drive system 2 content important notice 4 for your safety 5 6 1 drive unit (mm g33.250/350) 7 1.1 advantages 7 1.2 scope of application 7 1.3 product naming protocol 7 1.4 main techinialc parameters 8 1.5 9 2 system installation 10 2.1 10 2.2 11 2.3 display installation (dp c07.Uar...
Page 3: 5 Battery (Bt Co1)
41 dealer manual max drive system 5 battery (bt co1) precautions • if any liquid leaking from the battery gets into your eyes, rinse immediately with clean water (e.G. Tap water). Seek medical advice immediately; otherwise the battery liquid may damage your eyes. • do not recharge the battery in pla...
Page 4: 5.1 Using The Battery
42 battery (bt co1) dealer manual max drive system 5.1 using the battery properly the battery can be charged at any time no matter how much power is left. However, in the following cases, the battery needs to be fully charged. Make sure you use the specified charger to charge the battery. • the batt...
Page 5: 5.3 Battery Capacity
43 dealer manual max drive system 5.3 battery capacity display press the battery level display switch lightly. The lights indicating the remaining battery capacity will appear: battery capacity display remaining battery capacity 11~30% 31~50% 51~70% 71~90% 91~100% light on light off 5.4 battery heal...
Page 6
44 battery (bt c01) dealer manual max drive systme 5.5 battery installation a battery pack lock b battery insert the battery pack from the tail of the carrier onto the rail. Push it to the front until you hear it snap into place in the battery pack lock. Please make sure the battery pack is locked t...
Page 7: 6 Display (Dp C07.Uart)
45 dealer manual max drive system 6 display (dp c07.Uart) 6.1 specifications and parameters of the display • 36v / 43v / 48v power supply; • rated current: 10 ma • maximum operating current: 30 ma • power-off leakage current: • operating current supplied to the controller: 50 ma • operation temperat...
Page 8
46 display (dp co7.Uart) dealer manual max drive system 6.3 function overview and key definitions 6.3.1 function overview • use of a two-way serial communication protocol, simple operation of the display via the external 5-key keypad. • speed display: displaying the real-time speed as speed, the max...
Page 9
Dealer manual max drive system 47 j distance mode: display of the single-trip distance trip and the total distance total k battery level: 10-segment battery indication; the voltage that each segment represents can be customized 6.3.3 key definitions a up b down c headlight d on/off e mode.
Page 10: 6.4 Normal Operation
48 display (dp c07.Uart) dealer manual max drive system 6.4 normal operation 6.4.1 o n/ off switch t urn on the device. Press and hold for 2 seconds to power on the display. Press and hold again for 2 seconds to power off the display. If the bike is not used, after 5 minutes (time can be set) the di...
Page 11
Dealer manual max drive system 49 6.4.4 headlight/ display backlight switch press for 2 seconds. The backlight of the display as well as the headlight and taillight will be turned on. Press again for 2 seconds to power off the display backlight/headlight/taillight. (if the display is turned on in a ...
Page 12: 6.5 Parameter Setting
50 display (dp c07.Uart) dealer manual max drive system 6.4.6 battery status indication when the battery status is normal, a certain number of the battery lcd segments as well as the border light up according to the actual quantity of charge. If all of the 10 segments will black out with the border ...
Page 13
Dealer manual max drive system 6.5.2 setting preparation when the display is active, press twice (interval - rameter setting state, in which the display parameters can be set. Press twice again (interval seconds) to return to the main menu. Menu for entering the parameter settings in the parameter s...
Page 14
52 display (dp co7.Uart) dealer manual max drive system 6.5.5 light sensitivity when the speed field displays bl0, use / to choose a figure between 0 and 5. The higher the chosen figure, the higher the light sensitivity. After this setting, briefly press ( enter the setting interface of backlight br...
Page 15
53 dealer manual max drive system 6.5.7 automatic off time when the speed field displays off, press / to choose a figure between 1 and 9. The gures indicate the minutes that it takes to automatically shut down the display. After this setting, briefly press ( enter the setting interface of maintenanc...
Page 16
54 dispaly (dp co7.Uart) dealer manual max drvie system flash for 4 seconds, indicating that maintenance is necessary. • the maintenance alert function can be disabled: settings maintenance alert (ma) main - tenance alert (ma) 0. (maintenance alert can also be set via a computer. This requires a usb...
Page 17
55 dealer manula max drive system 6.6 error code definitions the max-c966 display can show e-bike faults. When a fault is detected, the icon will be displayed. In the speed field one of the following error codes will be displayed: error code error description error-shooting method “03” brake enabled...