Bahamas Breeze FS45-3ER Owner's Manual - page 3
4h
2h
1h
OTHER OPERATION INSTRUCTIONS
1. Plug the power supply cord into a wall outlet.
2. To make / stop the fan head oscillate, push down/pull up the oscillation
knob(8).
3. The airflow can be adjusted upward or downward by pushing the grilles
slightly to the desired up or down direction.
4. The height of the fan can be adjusted. First, loosening the height
Adjustment ring carefully, raising or lowering the pipe. Then firmly
retightening the ring.
INSERT THE BATTERIES PROVIDED
1. Press dawn on the battery compartment
cover and slide it out.
2. Insert the batteries, making sure that the
positive terminals are facing the proper
way.
3. Replace the cover.
FINAL ASSEMBLY
Attach fan body (10) to internal pipe (12).
OPERATING INSTRUCTIONS
1. “ ” TIMER KEY
When this key is touched repeatedly, the time
to be set 1, 2 and 4 hours and the correspond
pilot lamp will light. If the lamp don’t light after
you touched the key, the fan will run
continuously.
2. “ ” ON/SPEED/OFF KEY
This key is for switching fan and setting speed.
When you touch it repeatedly, the fan speed
will circle by ON (LOW)-MED -HI(HIGH)-OFF.
THE BATTERY WARNING AS BELOW
1. “Do not dispose of batteries in fire, batteries may explode or leak.”
2. -Do not mix old and new batteries.
3. -Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
HOW TO USE THE REMOTE CONTROLLER CORRECTLY
Point the remote controller at the receptor on body of the fan and press the
desired button. The remote controller will work at distances of up to roughly
six meters and the angle of 60 degree included between right and left from the
receptor. The batteries must be removed from the remote controller
before it is scrapped and that they are disposed of safely.
STORAGE
Make sure to disassemble and clean the fan before storing. Retain the
original packaging for the purpose of storing your fan. Always store fan in
a dry place. Never store it while it is still plugged in. Never wrap the cord
tightly around the fan, and do not put any stress on the cord where it enters
the fan, as it could cause the cord to fray and break.
BLADE AND GRILLES ASSEMBLY
1. Take the spinner (2) from the instruction manual bag and unscrew the
plastic nut (5) counter-clockwise to remove it.
2. Set the rear grille (6) in the proper position and make the handle
upward.
3. Screw on plastic nut tightly to attach rear grille.
4. Discard plastic sleeve on the motor shaft(4).
5. Install the fan blade(3) onto the motor shaft until it reaches the
retaining pin.
6. Screw spinner onto motor shaft counter -clockwise to blade.
7. Secure both grilles firmly by tightening the clips.
COLUMN ASSEMBLY
1.Attach external pipe (14) to stand (16
)
with 4 screws.
2.Unscrew height adjustment ring (13).
3.Slide stand ornament
(
15
)
down the external pipe to rest on the stand.
4.Pull out the internal pipe (12) and fasten the height adjustment ring back.
CAUTION: Height adjustment ring must be fully fastened before the
assembly of the motor section to the stand.
3
4
OPEN