Bahamas Breeze FW40-F3 Owner's Manual - page 3
INSTALLATION
The fan should be installed on a solid wooden or
pillar, which stands vertically to the floor.
Caution: To prevent the fan from falling off, do not
install it on walls less then 10 cm thick or made of
materials that are easily damaged.
Installing the mounting bracket
Fix the supplied mounting bracket firmly to the wall
using the three screws.
NOTE: The bracket should be positioned at least
35 cm from the ceiling and at least 30 cm from
adjoining wall.
Installing the stand
Mount the stand on the bracket by inserting the
bracket catch into the slot on the stand.
Fix the stand onto the bracket with a retaining nut.
NOTE: If the retaining nut does not pass through the
holes, push the stand downwards until it is fully
mounted on the bracket.
3
4
SPEED ADJUSTMENT
Adjust to the desired speed by pulling the pull switch (A).
0---Stop 1---Low 2---Medium 3---High
OSCILLATION CONTROL
Adjust the position of the oscillation by pulling the pull
switch (B).
Push the guard lightly to the desired up or down direction.
CLEANING
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with mild soap and damp cloth or
sponge. Thoroughly remove soap film with clean water.
3. Be sure not to make water or other liquid enter the inside of the motor.
USER SERVICING INSTRUCTIONS
1. Grasp the plug and remove it from the receptacle
or other outlet device. Do not unplug by pulling
on the cord.
2. Open the fuse cover. Slide opens the fuse access
cover on top of attachment plug towards blades.
3. Remove the fuse carefully. Push the fuse from the other side or turn the
fuse holder over to remove the fuse.
4. Risk of fire. Replace the fuse only with 2.5 A, 125 Volt fuse.
5. Close the fuse cover. Slide closed the fuse access cover on top of the
attachment plug.
6. Risk of fire. Do not replace attachment plug. Contains a safety device
(fuse) that should not be removed. Discard product if the attachment plug
is damaged.
NOTICE:
1. When you replace fuse, please don’t operate suddenly or overexert, or
else the product will be damage or cause accident.
2. When you feel it hard to be operated, please make sure you have got the
right way.