Baileigh DP-1512B Operating Instructions Manual - page 9
7
7
SAFETY PRECAUTIONS (cont.)
12. Stay alert. Watch what you are doing and use common sense. DO NOT operate any tool or
machine when you are tired.
13. Drill Operation. Never start the drill press with the drill bit pressed against the piece part.
Feed the drill bit slowly and evenly into the piece part. Position work to avoid drilling into the
table.
14. Clearing Chips. Turn the machine OFF and clear chips and scrap pieces with a brush or
with compressed air.
15. Operating Speed. Always operate the drill press at speeds appropriate for the size drill bit
and material you are drilling.
16. Observe work area conditions. DO NOT use machines or power tools in damp or wet
locations. Do not expose to rain. Keep work area well lighted. DO NOT use electrically
powered tools in the presence of flammable gases or liquids.
17. DO NOT bypass or defeat any safety interlock systems.
18. Know the location of the ON - OFF switch and the
“E”- STOP button.
19. Keep visitors a safe distance from the work area.
20. Keep children away. Children must never be allowed in the work area. DO NOT let them
handle machines, tools, or extension cords.
21. DO NOT operate machine if under the influence of alcohol or drugs. Read warning
labels on prescriptions. If there is any doubt, DO NOT operate the machine.
22. DO NOTtouch live electrical components or parts.
23. Be Sure all equipment is properly installed and grounded according to national, state, and
local codes. If machine is equipped with a three-prong plug, it should be plugged into a
three-hole electrical receptacle. If an adapter is used to accommodate a two-prong
receptacle, the adapter plug must be attached to a known ground.
24. Inspect power and control cables periodically. Replace if damaged or bare wires are
exposed. Bare wiring can kill!
25. Maintain machine in top condition. Keep clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
26. Reduce the risk of unintentional starting. Make sure switch is in
“OFF” position before
plugging in power cord.
27. Never leave machine running unattended. TURN POWER OFF
. Don’t leave machine
until it comes to a complete stop.