Bailey 400-2 Service Manual - page 16
16
Service Schedule
In order to validate the factory backed warranty
package, your caravan must be serviced by an
approved Bailey Service centre every 12 months
(or within 6 weeks of each anniversary of purchase)
in accordance with the NCC recommended service
schedule.
A full listing of the current Approved Bailey Centres
can be found on the Retailer Network pages of our
website @www.bailey-caravans.co.uk.
In no circumstances should the body shell fixings
be tampered with or adjusted by the caravan owner.
In instances where this has occurred the warranty
will be automatically invalidated.
Standard Moisture survey for Alu-tech
construction caravans.
The following moisture survey must be
carried out using a calibrated moisture
meter every 12 months by an Approved
Bailey Service Centre.
Readings should be taken on the floor section of
the vehicle in positions where the holes created
by the meter’s probes are not visible i.e. behind
seals, in bed boxes or in cupboard bases. It is
important to make sure that the probes are free
from moisture and the surface of the floor is free
from condensation.
Readings below 20% are considered acceptable.
Readings greater than 20% will identify areas that
need further investigation and possible remedial
work.
All other parts of the Alu-Tech caravan should be
checked visually for moisture ingress.
Thermal Insulation Grade
All Alu-Tech Bailey Caravans are manufactured and
approved by the NCC to EN1645 thermal grade III.
!
This has been approved using the caravan heating
system on both electric and gas.
Grade III is classified as being able to achieve an
average temperature difference of 35 degrees
centigrade between inside the caravan and outside
when the exterior temperature is -15 degrees.