2. Remove operating instructions, manufacture statement of origin,and owners manual located on top of atv. . Remove cardboard carton from metal frame e - rev - a set-up instructions wd90u/cn90u.
2 3. Remove bolts as indicated in photo from both sides of metal frame 4. Carefully remove metal frame 5. Remove wire straps from front bumper 6. Remove wire straps from rear axle. Removal from crate.
3 7. Loosen plastic guard bolt and remove plastic guard. 8. Loosen all bolts and lift handle bars to desired position, tighten handle bar bolt. Torque to 25nm (8.5ft.Lb). Replace the plastic guard and tighten bolt. Handlebar assembly.
4 flag pole assembly 9. Remove nut from flag holder assembly. 0. Attach flag holder assembly to mounting bracket on rear rack of atv and tighten nut. . Insert flag pole into flag holder assembly. Mounting bracket flag holder assembly nut nut flag holder assembly.
5 2. Refer to battery section of owners manaul for correct installation and charging of battery. Battery is located under the seat battery installation.
6 oil cap !!Warning!! This engine may be shipped with pack- ing oil in it. This oil should be drained and replaced with new oil as described in the owners manual. Never attempt to start engine without first replacing the engine oil with the proper amount and grade as described in the owners manual. ...
