2. Remove metal crate. 1. Remove cardboard carton from metal frame. Reva 080707 set-up instructions ba49 atv removal from crate.
Parts and hardware front bumper left side panel side panel hardware front wheel front wheel covers handlebar cover battery strap handlebar handlebar hardware 3. Attach handlebars to steering stem using 8mm bolts (qty 4) and handlebar clamps. Torque bolts to 17ft.Lbs. Upper handlebar clamps lower han...
Front wheels front bumper and side panel 4. Attach left and right front wheels to hub using 8mm nut (qty 3 per side). Torque nut to 20ft.Lbs. 5. Attach wheel cover. 6. Attach front bumper to frame using 8mm bolts (qty 2 per side) torque bolts to 17ft.Lbs. 7. Attach left side panel to fender using 2 ...
Battery installation warning the following procedure is very dangerous and should be performed with utmost care and attention. Wear protective eye wear, rubber gloves, and have water available should electrolyte come in contact with skin or eyes. Keep all children away from the area while this proce...
Battery installation preparing the battery: · place battery on level surface. Remove sealing tape from top. (see figure 20) · take the electrolyte container out of the plastic bag. · place electrolyte container upside down with the sealed silver mouths of the electrolyte bottles in line with the six...
Battery installation 3. Charging rate: charge battery @ 0.7 amps for 5 ~ 10 hours. • after charging is complete, press down firmly with both hands to seat the caps. (do not pound or hammer.) the battery is now sealed. (see figure 25) • locate battery compartment on atv. The battery compartment is lo...
Oil cap gas cap 9. Fill engine with correct amount of oil. Refer to owners manual for oil type and quantity. 10. Fill gas tank as specified in owners manual. 11. Refer to owners manual for proper starting instructions. Gas and oil caution the engine oil should be drained and replaced with new oil be...
